Manual Bosch GAS 35 L SFC PLUS Professional (page 21 of 230) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

594769

Zoom out

Zoom in

1/230

English | 21

Bosch Power Tools 1 609 92A 0XC | (29.9.14)

The delayed action shutdown of the Automatic Start/Stop

continues to run for up to 15 seconds in order to extract re-

sidual dust from the vacuum hose.

– To switch the vacuum cleaner off, set the mode

selector switch 5 to the “Off” symbol.

Wet Vacuuming

 Do not vacuum inflammable or explosive fluids; for ex-

ample, benzene, oil, alcohol, solvents. Do not vacuum

hot or burning dust. Do not operate the machine in

rooms where the danger of an explosion exists. The

dusts, vapours or fluids can ignite or explode.

 The vacuum cleaner may not be used as a water pump.

The vacuum cleaner is intended for vacuuming air and wa-

ter mixtures.

 Before any work on the vacuum cleaner itself, pull the

mains plug.

Note: The requirements for the ingress degree (dust

category L) have only been proven for dry vacuuming.

– Remove the disposal bag 23 or the dust bag and empty the

container 1 before wet vacuuming.

Note: For easier disposal when vacuuming liquid-solid mix-

tures, use a wet filter bag (accessory), which separates liq-

uids from solids.

– Mount the rubber lips into the floor nozzle (see “Inserting

the Rubber Lip”, page 20).

– Switch the semi-automatic filter cleaning (SFC+) off (see

“Deactivating the SFC+”, page 21).

The vacuum cleaner is equipped with filling-level sensors 35.

When the maximum filling height is reached, the vacuum

cleaner switches off. Set the mode selector switch 5 to the

“off” symbol.

Note: When vacuuming non-conductive liquids (e. g. drilling

emulsion, oil and grease), the vacuum cleaner is not switched

off when the container is full. The level must be monitored

continuously and the container emptied in time.

To prevent the formation of mould after wet vacuuming:

– Take out the flat-fold filter 24 and allow it to dry well.

– Remove the vacuum cleaner lid 8 open the filter cover 34

and allow both components to dry thoroughly.

Filter Cleaning

The filter cleaning system must be actuated at the latest when

the vacuuming performance is no longer sufficient.

The filter cleaning frequency depends on the type and amount

of dust. With regular usage, the maximum vacuuming perfor-

mance is maintained longer.

Semi-Automatic Filter Cleaning (see figure I)

With semi-automatic filter cleaning (SFC+), the lamellas of

the flat-fold filter are cleaned from deposited dust by revers-

ing the airflow.

Note: The semi-automatic filter cleaning is factory-activated

(SFC+ switch 18 in position I).

– Actuating the SFC+ filter cleaning

Shut or block off the nozzle or vacuum-hose opening with

your palm.

Or, with the SFC+ module 20 mounted:

Press the actuator 33 down for approx. 10 seconds.

– Deactivating the SFC+

Push the SFC+ switch 18 toward the front (position 0).

– Activating the SFC+

Push the SFC+ switch 18 toward the rear (position I).

Maintenance and Service

Maintenance and Cleaning

 Before any work on the vacuum cleaner itself, pull the

mains plug.

 For safe and proper working, always keep the vacuum

cleaner and ventilation slots clean.

 Wear a dust protection mask when maintaining and

cleaning the vacuum cleaner.

If the replacement of the supply cord is necessary, this has to

be done by Bosch or an authorized Bosch service agent in or-

der to avoid a safety hazard.

A dust-technical inspection is to be carried out at least once

every year by the manufacturer or an instructed person, e. g.

for damage of the filter, tightness against leakage of the vacu-

um cleaner and function of the control/monitoring unit.

For category L vacuum cleaners that were in contaminated

environments, the exterior as well as all machine parts should

be cleaned or treated with sealants. When performing mainte-

nance and repair work, all contaminated components that

cannot be cleaned to satisfactory must be disposed of. Such

components must be disposed of in impermeable plastic bags

conforming with the valid regulations for the disposal of such

waste.

For maintenance on behalf of the user, the vacuum cleaner

must be disassembled, cleaned and maintained as far as fea-

sible, without causing a risk for the maintenance personnel or

other persons. Prior to disassembly, the vacuum cleaner

should be cleaned in order to prevent any risks. The room/en-

closure in which the vacuum cleaner is disassembled should

be well ventilated. Wear personal protective equipment dur-

ing maintenance. After the maintenance, the maintenance ar-

ea should be cleaned.

Removing/Replacing the Flat-fold Filter

(seefiguresJ1–J2)

Replace a damaged flat-fold filter 24 immediately.

– Pull the locking latch 14 and open the filter cover 34.

– Grasp the flat-fold filter 24 by the fins, pull up and remove.

– When taking out the flat-fold filter 24, remove any accumu-

lating dust and debris from the closing edge of the filter

cover 34 using a moist cloth.

– Insert the new flat-fold filter 24; observe proper and tight

seating.

– Shut the filter cover 34 again (must be heard to engage).

Container

– Wipe out the container 1 from time to time with a commer-

cially available, non-scouring cleaning agent and allow to

dry.

OBJ_BUCH-1702-003.book Page 21 Monday, September 29, 2014 2:58 PM

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bosch GAS 35 L SFC PLUS Professional in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 27,48 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bosch GAS 35 L SFC PLUS Professional Manual

Product: