Manual Bosch GAS 35 L SFC PLUS Professional (page 20 of 230) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

594769

Zoom out

Zoom in

1/230

20 | English

1 609 92A 0XC | (29.9.14) Bosch Power Tools

Inserting a Disposal Bag

– Unlock the latches 9 and remove the vacuum lid 8.

– Insert the disposal bag 23 into the container 1 with the fill-

ing opening toward the front.

– Pull the filling opening over the connection flange into the

recess of the connection flange.

– Make sure that the disposal bag 23 faces completely

against the interior sides of the container 1.

– Fold the rest of the disposal bag 23 over the edge of the

container 1.

– Reattach the vacuum lid 8 again and lock the latches 9.

Removing and Closing the Disposal Bag

– Unlock the latches 9 and remove the vacuum lid 8.

– Pull the full disposal bag 23 toward the rear off of the con-

nection flange.

– Carefully remove the disposal bag 23 out of the vacuum

cleaner without damaging it.

When doing this, pay attention that the disposal bag does

not get caught or ripped open against the connection

flange or other sharp objects.

– Pull the cover off of the adhesive strip, close the disposal

bag and tape it shut.

Afterwards, tie off the disposal bag 23 below the filling

opening with the pulled off cover of the adhesive strip.

Replacing/Inserting the Dust Bag (Accessory)

– Unlock the latches 9 and remove the vacuum lid 8.

– Pull off the full dust bag from the connection flange toward

the rear. Close the opening of the dust bag by folding down

the lid. Remove the closed dust bag from the vacuum

cleaner.

– Work the new dust bag over the connection flange of the

vacuum cleaner. Make sure that the dust bag faces com-

pletely against the interior sides of the container 1 over its

full length.

– Reattach the vacuum lid 8 again and lock the latches 9.

Inserting the Rubber Lip (Wet Vacuuming)

(see figure F)

Note: The requirements for the ingress degree (dust

category L) have only been proven for dry vacuuming.

– Carefully pry the brush inserts 27 out of the floor nozzle 28

using a suitable tool.

– Insert the rubber lips 26 into the floor nozzle 28.

Note: The structured side of the rubber lips must face out-

ward.

Attaching an L-Boxx (see figure G)

For transport of the vacuum cleaner and for place-saving stor-

age of VAC accessories and/or power tools, an L-Boxx can be

mounted on the vacuum cleaner lid.

– Mount the L-Boxx onto the retainers 7.

 Do not carry the vacuum cleaner by the carrying handle

of the mounted L-Boxx. The vacuum cleaner is too heavy

for the carrying handle of the L-Boxx. Danger of injury and

causing damage.

Operation

Starting Operation

 Observe correct mains voltage! The voltage of the pow-

er source must agree with the voltage specified on the

nameplate of the vacuum cleaner. Equipment marked

with 230 V can also be operated with 220 V.

 Please inform yourself about the valid regula-

tions/laws for your country concerning the handling of

materials that are hazardous to one’s health.

The vacuum cleaner is suitable for vacuuming and extracting

the following materials:

– Dusts with an exposition limit value > 1 mg/m

The vacuum cleaner may generally not be used in rooms

where the danger of an explosion exists.

To save energy, only switch the vacuum cleaner on when us-

ing it.

To ensure optimal vacuuming performance, always complete-

ly unwind the vacuum hose 21 from the vacuum cleaner lid 8.

Dry Vacuuming

Vacuuming of deposited dusts

– To switch the vacuum cleaner on, set the mode

selector switch 5 to the “vacuuming” symbol.

– To switch the vacuum cleaner off, set the mode

selector switch 5 to the “Off” symbol.

Extraction of dusts resulting from running power tools

(see figure H)

 An adequate ventilation rate (L) must be provided for

when the outgoing air is circulated. Observe the re-

spective national regulations.

A socket outlet with earthing contact 3 is integrated in the

vacuum cleaner. An external power tool can be connected

there. Observe the maximal allowable load of the connected

power tool.

– Mount the tool sleeve 19 (see “Mounting the Tool Sleeve”,

page 19).

– Insert the tool sleeve 19 into the vacuum connection of the

power tool.

Note: When operating power tools that have a low air infeed

into the vacuum hose (e. g. jigsaws, sanders, etc.), open the

air diffuser 32 of the tool sleeve 19. This measure will ensure

trouble-free semi-automatic filter cleaning (SFC+) operation.

Turn the ring above the air diffuser 32 until the opening is at

its maximum size.

– To start the vacuum cleaner’s automatic

Start/Stop feature, set the mode selector

switch 5 to the “Automatic Start/Stop” sym-

bol.

–To start the operation of the vac, switch on the power tool

connected to the socket 3. The vacuum cleaner starts au-

tomatically.

– Switch the power tool off to end the vacuuming.

OBJ_BUCH-1702-003.book Page 20 Monday, September 29, 2014 2:58 PM

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bosch GAS 35 L SFC PLUS Professional in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 27,48 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bosch GAS 35 L SFC PLUS Professional Manual

Product: