780622
14
Zoom out
Zoom in
Previous page
1/52
Next page
Installation
Condens 7000 WP – 6721841195 (2022/01)
14
Assembly on the wall
NOTICE
If the boiler may be damaged if attached incorrectly.
Use suitable fixing materials for the condition of the masonry and
weight of the boiler. The fixing materials provided are only suitable for
installation on concrete walls.
Only use fixing materials that are suitable for the construction
which will be supporting the boiler.
Check whether the wall has sufficient load-bearing capacity based
on the dimensions and weight of the boiler. ( § 15.2, p. 47).
Mount a fastening structure if required.
Only use fixing materials that are suitable for the structure to which
the boiler is to be attached. ( Tab. 6).
Table 6 Specification of the fixing materials
Determine the position of the boiler on the wall.
Mark the boreholes using the enclosed mounting rail [1].
Install the mounting rail on the wall using a spirit level to make sure
it is level [2 + 3 + 4].
Fig. 11 Installing the mounting rail on a concrete wall
Hook the boiler into the mounting rail.
Align the boiler using a spirit level and adjusting screw on the rear.
Fig. 12 Aligning the boiler on the wall
6.4 Connecting on the heating and gas side
The boiler can be connected on the heating and gas side in 2 ways:
using a connection set (accessory, § 6.5, p. 14),
without connection set ( § 6.8, S. 16).
6.5 Mounting the connection set (accessories)
NOTICE
Installation damage due to incorrect excess pressure of the safety
valve.
The connection set must be equipped with a safety valve.
Check whether the excess pressure of the safety valve is suitable for
the required operating pressure and the components in the heating
system.
Replace the pre-installed safety valve with a safety valve with a
suitable excess pressure (accessory).
The following components have been incorporated into the connection
set:
Gas valve;
Service shut-off valves;
Pressure gauge
•Safety valve;
•Pump;
Fill and drain valve.
These components can be found in the overview drawing ( § 2.11, p.
6).
Wall type Fixing materials Minimum load [N]
Concrete See scope of delivery 10001) Per fixing
point.
1) The load applies for tensile and shear loads.
Solid lime sandstone
Others Not included: to be
decided by the installer.
4.
3.
2.
1.
10011604-001
0010030948-001
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Condens GC7000WP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Condens GC7000WP in the language / languages: English as an attachment in your email.

The manual is 15.02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch Condens GC7000WP

Bosch Condens GC7000WP User Manual - English - 12 pages

Bosch Condens GC7000WP Installation Guide - German - 60 pages

Bosch Condens GC7000WP User Manual - German - 12 pages

Bosch Condens GC7000WP Installation Guide - Dutch - 56 pages

Bosch Condens GC7000WP User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info