780622
12
Zoom out
Zoom in
Previous page
1/52
Next page
Condens 7000 WP – 6721841195 (2022/01)
12
Installation
5.3 Water quality
Unsuitable or contaminated heating and tap water can lead to faults
in the boiler and can damage the heat exchanger or DHW supply
among other things due to sludge formation, corrosion or
calcification. Please get in touch with the manufacturer if you require
additional information on the water quality. You will find the relevant
addresses on the back of this document.
Using the supplied “Water quality operator's log” determine the water
volume Vmax:
If the amount of fill and top-up water is already greater than the
calculated water volume Vmax:
Use the water treatment as specified in the “Water quality operator's
log”.
If the amount of fill and top-up water is less than the calculated water
volume Vmax:
Purge and clean the heating system if required.
Only use untreated potable water.
Do not use chemical additives (e.g. inhibitors or agents that increase
or reduce the pH), apart from as specified in § 5.3.1.
5.3.1 Water conditioning and treatment
NOTICE
Damage to appliance due to sealing agent in the heating water.
Addition of sealing agent to the heating water is not permitted.
Conditioned water is water that has been softened or desalinated and to
which no chemicals have been added. Treated water is unconditioned or
conditioned water to which chemicals have been added.
The following water conditioning and water treatment measures have
been approved for use by Bosch:
Table 5 Additives
For information on concentrations and applications, contact the
supplier of the additive.
5.4 Maximum flow temperature
NOTICE
Too much chloride in the heating water can damage the appliance.
If the chloride content in the heating water exceeds 150 ppm, the
boiler may be damaged if the heating water temperature is higher than
80 °C. If the maximum flow temperature is set higher than 80 °C, the
water treatment must be adapted in order to reduce the chloride
content.
If the chloride content is more than 150 ppm, carry out a water
treatment as described in the supplied "Manual for water quality".
The boiler is supplied with a set maximum flow temperature of 80 °C as
standard. Under standard conditions, this maximum boiler temperature
is sufficient to cover the heating load and also guarantee the service
life of the boiler.
A higher maximum flow temperature may however be required for
certain installations. In these cases, the chloride content of the heating
water must be checked and reduced if necessary.
With the chloride content of the heating water.
If the chloride content is more than 150 ppm, perform water
treatment as described in the supplied "Manual for water quality".
Set the maximum flow temperature to the required value ( § 9.4.2,
p. 26).
Contact the manufacturer for more information. You will find the
relevant addresses on the back of this document.
6 Installation
WARNING
Risk of explosion
Close the gas valve before working on gas-carrying components.
After completing the work, check the tightness of all gas-carrying
components.
6.1 Unpacking the boiler
The packaging material is fully recyclable.
Dispose of the boiler packaging after installing the
boiler at a recycling point.
Remove the outer packaging by setting the boiler upright and pulling
it up and off.
Avoid damaging the connections on the boiler at the top and
bottom.
Cover the flue outlet adapter of the boiler during assembly.
6.2 Checking the gas type
Check whether the gas type to be connected to the appliance
corresponds to the gas type specified on the data plate. (§ 2.11,
p. 6 ).
6.3 Setting up the boiler The boiler can be
installed in two ways:
Installation on a frame (accessory).
Installation on the wall.
To make full use of the modular design of the system, it is advisable to
install the boiler in combination with the frame.
Installation on the frame (accessory)
WARNING
Physical injury due to tipping of the boiler.
The frame must be securely attached to the floor or wall so that the boiler
cannot tip over.
Use fixing materials that are suitable for the subsurface or wall and
offer a sufficient hold.
Fasten the frame to the floor with the bracket (included).
If drilling in the floor is not permitted fasten the frame to the wall.
Mount the cross bars [1] to the stands [2].
Secure the cross bars with the brackets [3] (included).
Place the frame at the required location in the installation room.
Application Product name Max.
concentration
[%]
Demineralisation Demineralisation/
desalination with mixed
bed cartridges
In accordance with
the supplied
"Manual for water
quality"
Inhibitor/antifreeze Fernox Alphi 11 40
Antifreeze Noburst AL 40
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Condens GC7000WP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Condens GC7000WP in the language / languages: English as an attachment in your email.

The manual is 15.02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch Condens GC7000WP

Bosch Condens GC7000WP User Manual - English - 12 pages

Bosch Condens GC7000WP Installation Guide - German - 60 pages

Bosch Condens GC7000WP User Manual - German - 12 pages

Bosch Condens GC7000WP Installation Guide - Dutch - 56 pages

Bosch Condens GC7000WP User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info