809317
19
Zoom out
Zoom in
Previous page
1/44
Next page
Commissioning
19
Compress 3400i AWS – 6721852066 (2023/01)
6.2 Venting the indoor unit
Fig. 16 Indoor unit with an integrated electric booster heater and heating system
[Z1] Heating system (without mixing valve)
[1] Outdoor unit
[2] Manual air vent valve
[PC0] Primary circulation pump
[VC1] Heating system valves
[VC2] Drain valve
[VC3] Valves for the heating system
[VL1] Automatic air vent valve
[GC1] Pressure gauge
[SC1] Magnetic filter valve
[VW1] 3-way diverter valve
[VW2] Fill valve
See Fig. 16:
1. Connect the power supply to the outdoor and indoor units.
2. Activate "Only auxiliary heater" and make sure that the heating
circulation pump PC1 is running (if installed).
3. Remove the pulse width modulation plug PC0 from the primary
circulation pump PC0 so that it can operate at maximum speed.
4. Deactivate the "Only auxiliary heater" function when no more air is
coming out of the VL1 or the manual air vent valve on top of the
electric heater. Close the manual air vent valve.
5. Connect the PC0 pulse width modulation plug to the heating pump.
6. Clean the particle filter SC1.
7. Also vent via the other air vent valves of the heating system (e.g.
radiators).
8. Check the pressure on the pressure gauge GC1 and top up with the
fill valve VW2 if needed. The pressure should be 0.3–0.7 bar above
the pressure set in the expansion vessel.
9. Check that the heat pump is running and that there are no alarms.
6.3 Adjusting the operating pressure of the heating
system
Table 9 Operating pressure
Top up to 1.5–2.0 bar unless otherwise specified.
If the pressure does not remain constant, check whether the heating
system has any leaks and if the capacity of the expansion vessel for
the heating system is sufficient.
VC1 VC2
T
T
Z1
VC3
VW1
VW2
SC1
M
VL1
GC1
PC0
2
1
0010035629-001
Display on the pressure gauge
1.2 bar Minimum charge pressure. When the system is cold, the
operating pressure must be kept at roughly 0.3–0.7 bar
above the pre-charge pressure of the nitrogen cushion in
the expansion vessel. The pre-charge pressure is 0.7–
1.0 bar as a rule.
3 bar Maximum charging pressure at maximum heating water
temperature: must not be exceeded (the pressure relief
valve will open).
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Compress 3400i AWS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Compress 3400i AWS in the language / languages: English as an attachment in your email.

The manual is 7.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch Compress 3400i AWS

Bosch Compress 3400i AWS User Manual - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info