697410

Bosch Compress 3000 - HP 200-1 E AI-F Manual

24
Zoom out
Zoom in
Previous page
1/40
Next page
6 720 646 804
24
Maintenance and repair
The decorative front cover must be removed to access
the valve.
In order to drain the water heater completely:
B Turn off the cold water supply.
B Open a hot water faucet or lift the handle on the relief
valve to admit air to the tank.
Fig. 17
B Open the drain valve.
5.5 Vacation and Extended Shutdown
If the water heater is to remain idle for an extended
period of time, the power and water to the appliance
should be turned off to conserve energy and prevent the
buildup of dangerous hydrogen gas.
The water heater and piping should be drained if they
might be subjected to freezing temperatures. After a
long shutdown period, the water heater’s operation and
controls should be checked by qualified service person-
nel. Make certain the water heater is completely filled
again before placing it in operation.
5.6 Cleaning the Filter
In the Auto and Economic modes, the heater moves air
through the system and out the back of the unit. The fil-
ter is in place to protect the evaporator from dirt and
dust.
A clean air filter is important to get the highest effi-
ciency. Occasionally this filter will need to be cleaned
(minimum is once a year).
B Leave the power on.
B Remove the filter from the top of the unit.
It is located in the top of the unit behind the hot and cold
inlet pipes.
B Grasp the plastic handle
B Slide the filter straight up until it clears the shroud.
Once it has beed removed, the filter can be wiped
clean with a damp rag or rinsed with warm water.
Fig. 18
Once the filter has been cleaned, it can be replaced by
aligning it into the slot in the top of the unit and sliding
it down into place. When the handle is flush with the top
of the shroud, it is seated.
When the clean filter has been reinstalled:
B Press ENTER and DOWN keys simultaneously for 2
seconds.
IMPORTANT: A dirty filter will make the system work
harder and result in a reduction of efficiency and
possible damage to the system. In order to get the best
energy efficiency available, make sure your filter is
clean.
5.7 Clearing the Condensation Drain
Tubes
There are two drain hoses that are attached to the back
of the heater. If both of these get clogged, water will
spill down the outside of the unit.
The primary drain is intended to carry all condensate
away. If it is clogged or if the hose is kinked, the conden-
sate will exit the secondary drain tube and onto the floor.
This is intended as a notification to the user that the pri-
mary drain is clogged.
B Remove the drain hose.
B Clear any debris and reattach.
Fig. 19
i
Note: refer to the Hydrogen Gas Caution
in the Operating Instructions.
i
If the filter gets too dirty, the unit will auto-
matically switch to Standard Electric
mode and energy savings will be lost.
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Compress 3000 - HP 200-1 E AI-F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Compress 3000 - HP 200-1 E AI-F in the language / languages: English as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info