697410

Bosch Compress 3000 - HP 200-1 E AI-F Manual

10
Zoom out
Zoom in
Previous page
1/40
Next page
6 720 646 804
10
Installation instructions
3 Installation instructions
The manufacturer’s warranty does not cover any
damage or defect caused by improper installation,
attachment or use of any type of energy-saving or other
unapproved devices (other than those authorized by the
manufacturer) into, onto or in conjunction with the water
heater.
The manufacturer disclaims any responsibility for such
loss or injury resulting from the use of such
unauthorized devices.
3.1 Tools required
• Wrench ¾"
• Phillips screwdriver
• Flat screwdriver
• Wire strippers
• Level
• Measuring tape
• Standard plumbing tools.
3.2 Location requirements
Locate the water heater in a clean, dry area as near as
practical to the area of greatest hot water demand.
Long uninsulated hot water lines can waste energy and
water.
Note: Because this unit draws in air from the room to
heat the water, the room must be at least 10' x 10' x 7'
(700 cubic feet) or larger. If the room is smaller, there
must be louvers installed to allow for adequate airflow.
Place the water heater in such a manner that the air fil-
ter, cover and front panels can be removed to permit
inspection and servicing, such as removal of elements,
draining the tank, or cleaning of the filter.
The water heater and water lines should be protected
from freezing temperatures and highly corrosive atmos-
pheres. Do not install the water heater in outdoor or
unheated, unprotected areas.
Fig. 5
NOTE: Auxiliary catch pan MUST conform to local
codes. Catch Pan Kits are available from the store
where the water heater was purchased, a building sup-
ply store or any water heater distributor.
Local installation regulations
This water heater must be installed in accordance with
these instructions, local codes, plumbing codes (UPC
or IPC), utility codes, utility company requirements or, in
the absence of local codes, the latest edition of the
National Electrical Code. It is available from some local
libraries or can be purchased from the National Fire Pre-
vention Association, Batterymarch park, Quincy, MA
02169 as booklet ANSI/NFPA 70.
Required clearances
It is recommended that there is 5-½” of clearance (air
space) between any object and the front and rear
shrouds.
Warning: To avoid the potential for
ignition and fire, the water heater should
not be installed in a space where liquids
which give off flammable vapors are to
be used or stored.
Caution: The water heater should not
be located in an area where leakage of
the tank or connection will result in
damage. In installations where risk of
water damage cannot be avoided, a
suitable catch pan, adequately drained,
must be installed under the water
heater.
Warning: This water heater SHOULD
NOT be installed in a space where
liquids which give off flammable vapors
are to be used or stored. Such liquids
include gasoline, LP gas (butane and
propane), paint or adhesives and their
thinners, solvents or removers.
Because of natural air movement in a
room or other enclosed space,
flammable vapors can be carried from
where their liquids are being used or
stored. Any arc within the water
heater's electronic controls can ignite
these vapors causing an explosion or
fire which may result in severe burns or
death to those in range, as well as
property damage.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Compress 3000 - HP 200-1 E AI-F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Compress 3000 - HP 200-1 E AI-F in the language / languages: English as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info