78165

Bosch AHS 52 Manual

24
Zoom out
Zoom in
Previous page
1/297
Next page
24 | English
F 016 L70 729 | (13.12.10) Bosch Power Tools
To cut the sides straightly, we recommend cut-
ting from bottom to top in the direction of
growth. Younger stems tend to move outwards
when cutting them from top to bottom, resulting
in shallow patches or holes in the hedge.
To reach a level finish, fasten a piece of string
along the length of the hedge at the required
height and use as an alignment guide. Cut the
hedge just above the string.
Always take care to avoid cutting into objects
such as wire, which could cause damage to the
cutting blades and the drive.
Anti Blocking
The garden product has a patented feature
which works as follows:
If the blade stalls on a tough material, the load
of the motor increases. The intelligent micro-
electronics senses this overload condition and
repeatedly reverses the motor, in order to pre-
vent stalling and to cut the material through.
This audible reversing cut action continues for
up to 3 s.
After cutting through, the garden product con-
tinues in its normal mode, or in case the over-
load condition continues the blades automati-
cally stop in the open position (e. g. in case a
piece of metal fence accidentally blocks the gar-
den product).
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your garden
product does not operate properly. If these do not identify and correct the problem, contact your
service agent.
f Warning: Switch off and remove the battery prior to any troubleshooting.
Problem Possible Cause Corrective Action
Hedgecutter does
not operate
Battery discharged Recharge battery; also see “Battery
Charging”
Safety switch not activated correctly see “Initial Operation”
Hedgecutter oper-
ates intermittently
Internal wiring of garden product
damaged
Contact Service Agent
On/Off switch defective Contact Service Agent
Motor reverses repeatedly then stalls
after 3 s.
see “Working Advice” (Anti Blocking)
Motor runs but
blades remain sta-
tionary
Internal fault Contact Service Agent
Cutting blade hot Cutting blade blunt Have blade sharpened
Cutting blade has dents Have blade inspected/overhauled
Too much friction, due to lack of lu-
bricant
Apply lubricant spray
Blade will not move Battery discharged Recharge battery; also see “Battery
Charging”
Garden product defective Contact Service Agent
Excessive
vibrations/noise
Garden product defective Contact Service Agent
OBJ_BUCH-564-006.book Page 24 Monday, December 13, 2010 12:55 PM
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch AHS 52 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch AHS 52 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 9,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info