78165
23
Zoom out
Zoom in
Previous page
1/297
Next page
English | 23
Bosch Power Tools F 016 L70 729 | (13.12.10)
Firstly, place the battery 6 as shown in the figure
onto the front of the battery charger (n) and
then press the battery 6 down at the rear (o).
To remove the battery, proceed in reverse order.
Due to the intelligent charging method, the
charging condition of the battery is automatical-
ly detected and the battery is charged with the
optimum charging current, depending on bat-
tery temperature and voltage.
This gives longer life to the battery and always
leaves it fully charged when kept in the charger
for storage.
Note: The charging procedure is only possible
when the battery temperature is within the al-
lowable charging temperature range, see sec-
tion “Technical Data”.
Flashing Battery Charge Indicator 10
The charging procedure is sig-
nalled by a flashing battery
charge indicator 10.
Continuous Lighting of the Battery Charge In-
dicator 10
Continuous lighting of the
battery charge indicator 10
indicates that the battery is
fully charged or that the tem-
perature of the battery is not within the allowa-
ble charging temperature range, and cannot be
charged for this reason. The battery is charged
as soon as the allowable charging temperature
range is reached.
When the battery is not inserted, continuous
lighting of the battery charge indicator 10 indi-
cates that the mains plug is inserted in the sock-
et and that the battery charger is ready for oper-
ation.
Charging Advice
With continuous or several repetitive charging
cycles without interruption, the charger can
warm up. This is not meaningful and does not in-
dicate a technical defect of the battery charger.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
The “Electronic Cell Protection (ECP)” protects
the lithium ion battery against deep discharging.
When the battery is run down or discharged, the
garden product is shut off by means of a protec-
tive circuit: The blade no longer moves.
Do not continue to press the
On/Off switch after the garden
product has been automatically switched off.
The battery can be damaged.
Operation
Initial Operation
Inserting the Battery (see figure A)
Insert the battery into the machine as shown.
The battery must be felt to engage.
Switching On (see figure B)
n Press and hold the On/Off switch 5 on the
rear handle.
o Pull the safety switch 4 upward.
p Then press the front On/Off switch 3.
Switching Off
Release the front 3 or rear 5 On/Off switch.
Working Advice (see figures CE)
f Warning: Hold the hedgecutter away from
yourself using both hands. Stand in a se-
cure and stable position.
f Always lubricate the cutting blade with pro-
tective spray before use.
Cuts stems up to 15 mm in thickness (max.).
When cutting, move steadily along the line of
cut, so that stems are fed directly into the cutter
blades. The double edge cutting blade enables
cutting in either direction, or with a side to side
motion.
Cut the sides of the hedge first, then the top.
W
ARN
I
N
G
OBJ_BUCH-564-006.book Page 23 Monday, December 13, 2010 12:55 PM
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch AHS 52 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch AHS 52 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 9,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info