714397
18
Zoom out
Zoom in
Previous page
1/28
Next page
EN
18
Installation
www.bora.com
5.6 Power connection
Observe all safety and warning information in the
Safety section.
Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO The power connection may only be established
by a certified specialist. He/she also assumes
responsibility for the proper installation and
commissioning.
The power supply line for use (pre-assembled) must be of
the type H05VV-F or H05VVH2-F as a minimum.
Cross-section: 3G 1.5 mm²
If the connection line has been damaged this must be
replaced by a special connection line. This may only
be done by an authorised member of the After Sales
Service team.
Establishing the power connection
Switch off the main switch/automatic circuit breaker
before connecting the cooktop.
Secure the main switch/automatic circuit breaker
against being switched back on without permission.
Make sure the power to the appliance is disconnected.
Connect the mains cable.
Only connect the cooktop using a permanent
connection to a power supply cable.
1
L1
2
N PE
220 - 240 V~
Fig. 5.12 Connection diagram 1-phase
Check that the cooktop has been correctly installed.
Switch on the main switch/automatic circuit breaker.
Put the cooktop into operation (see the Operation section).
Check that all the functions are working correctly.
5.7 Handover to user
Once installation is complete:
Explain the main functions to the user.
Explain all safety-related aspects of operation and
handling to the user.
Provide the user with the accessories and operating
and installation instructions for safe storage.
1
2
Fig. 5.10 Cooktop and height adjustment plates
[1] Cooktop
[2] Height adjustment plates
For surface mounting
Make sure that the sealing tape for the cooktop is flat
against the worktop.
For flush installation
Make sure that the sealing tape of the cooktop is
sealed well all the way round.
1
3
2
Fig. 5.11 Mounting brackets
[1] Mounting bracket
[2] Washer
[3] Screw
Affix the cooktop using the mounting brackets [1].
Use the screw [3] and the washer [2] to tighten the
mounting brackets with max. 10 Nm.
Check that the cooktop is positioned correctly.
Once all of the installation work is complete, seal the
devices with black, heat-resistant silicone sealant.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bora CCH1 Classic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bora CCH1 Classic in the language / languages: English as an attachment in your email.

The manual is 3,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bora CCH1 Classic

Bora CCH1 Classic User Manual - German - 28 pages

Bora CCH1 Classic User Manual - Dutch - 28 pages

Bora CCH1 Classic User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info