714520
18
Zoom out
Zoom in
Previous page
1/44
Next page
EN
18
Device description
www.bora.com
5.5.2 Safety shut-down
Cooking zone
Each cooking zone is switched off automatically when the
cooking zone in the power level exceeds the maximum
operating duration.
H
(residual heat display) is then displayed
in the cooking zone indicator (see the Device description
section).
Power level 1 2 3 4 5 6 7 8 9
Switch off after
x hours
8 6 5 5 4 1.5 1.5 1.5 1.5
Tab. 5.4 Overview of the safety shut-down
Switch the cooking zone back on (see Operating control)
if you want to put the cooking zone back into operation.
Cooktop extractor
The cooktop extractor switches off automatically if no
buttons are pressed for 120 minutes.
5.5.3 Overheating protection
The device is fitted with overheating protection.
The overheating protection can be triggered if:
Cookware is heated up empty.
Oil or fat is heated on high power.
A hot cooking zone is switched on again after a power cut.
There is insufficient ventilation below the cooktop (see
Cooktop air intake).
Before the overheating damages the electronics, one of the
following measures is taken:
The power level can no longer be increased.
The power level set is reduced.
The cooktop switches off completely.
After a sufficient cooling period, the cooktop can be used
again in full.
5.5.4 Automatic switch-off if the button is
pressed and held
The cooktop will be switched off automatically when
one or more sensor buttons are touched for longer than
10 seconds (finger contact, objects, soiling).
After a few seconds, the cooktop will switch off.
Remove the finger or object from the cooktop.
Clean the cooktop as required.
Where necessary, switch the cooktop back on.
5.5.5 Child safety lock
The child safety lock prevents the cooktop from being
switched on automatically. The child safety lock can only
be activated when the cooktop is switched on and all
cookingzoneshavebeenswitchedo(seetheOperation
chapter).
Humming may occur when using a high power level. It
decreases or disappears if the power level is decreased.
Crackling or whistling may occur due to the bases of
cookware made of different materials (e.g. sandwich
base).
Clicking sounds may occur during electronic
switching procedures especially at low power levels.
Whirring may occur when the cooling fan is switched
on. In order to increase the service life of the
electronic system, the cooktop is equipped with a
cooling fan. The cooling fan switches on automatically
if the cooktop is used intensively. You will hear a
whirring sound. The cooling fan may continue running
after the device has been switched off.
5.4 How the cooktop extractor works
5.4.1 power setting
The cooktop extractor has a power-enhancing power
setting.
This power setting makes it possible to suction away high
levels of cooking vapours more quickly. After 10 minutes,
the power setting is automatically switched to power level
2
.
5.4.2 Automatic after-run
The cooktop extractor fans continue to run at level 1 and
switch off automatically after 20 minutes.
5.4.3 Filter service display
The filter service display is activated once the cooktop
extractor has been operated for 150 hours. The activated
charcoal filters are exhausted (with recirculation only) and
the stainless steel grease filter needs to be thoroughly
cleaned.
F
appears (flashing) in the filter service display.
The filter service display is shown every time the
cooktop extractor is switched on and remains active
until the filter has been changed and the filter service
display is reset.
The cooktop extractor can still be operated without
limitations.
5.5 Safety devices
5.5.1 Residual heat display
INFO While
H
is displayed in the cooking zone
indicator (residual heat display), do not touch
the cooking zone or place any heat-sensitive
objects on top of it. Risk of burns and fire!
After switching it off, the cooking zone remains hot.
H
is displayed in the cooking zone indicator (residual heat
indicator). The cooking zone indicator will go out after
sufficient cooling time (temperature < 60°C).
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bora BIAS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bora BIAS in the language / languages: English as an attachment in your email.

The manual is 7,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bora BIAS

Bora BIAS User Manual - German - 44 pages

Bora BIAS User Manual - Dutch - 44 pages

Bora BIAS User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info