651928
15
Zoom out
Zoom in
Previous page
1/20
Next page
15
color, washing temperature and degree of soiling.
Bleach is alkaline and can damage your clothing, preferably does
not use bleach.
Detergents often leave residue in the clothes, which can cause bad
odor if not rinsed properly.
Detergent cannot easily get dissolved completely if there is too
much detergent or water temperature is rather low. It can remain in
clothes, pipes and washing machines to pollute the clothes.
Washing shall follow the weight of clothes, dirty degrees, local
water hardness as well as the recommendations from the detergent
manufacturers. Consult the water company if you are not clear of
water hardness.
Detergent drawer
CAUTION:
The dispenser is designed exclusively for the use of detergents for
washing machines!
NOTE:
Always add the detergent just before starting the wash cycle,
otherwise it could get damp and will not dissolve properly.
At the end of the wash cycle the detergent dispenser must be
empty.
I Chamber of detergent for the pre-wash.
II Chamber of detergent for the main wash.
Chamber for washing additives (fabric softener).
Do not exceed the MAX-marking.
Foam detection
Excessive foaming occurs by using too much detergent. This affects
the wash and rinse cycle. The function automatically checks the
foaming; excessive foam will be removed.
Adding laundry
Unravel the clothes before putting them into the appliance.
Each load should correspond to the nominal capacity of the appli-
ance. Do not overload the appli-ance. Different strengths, sizes and
types of laundry can affect the actual loading capacity. It is advisable
to load the appliance just that a normal circulation during washing is
possible.
Close the door. Make sure that no laundries are caught between the
door and seal.
Control panel
1 START/PAUSE-button: to start/pause the selected or running
program.
2 TEMPERATUR (temperature) -button: to select the washing tem-
perature. If no temperature is selected, the washing temperature is
cold. Note that the selection depends on the program.
Suppressing the acoustic signal, press the TEMPERATUR-but-
ton for several seconds to stop / reactivate the beep upon button
presses.
3 SCHLEUDERZAHL (spin speed) -button: to select the spin
speed. In the setting [0] spin stop, there is no spinning. Note that
the selection depends on the program.
Saving favorite program, after selecting the program, press the
SCHLEUDERZAHL-button for several seconds. Your favorite pro-
gram will be saved under „Mein Programm“ (My Cycle - program
selector switch). The program remains saved until you change it
with the same procedure.
4 ZEITVORWAHL (delay time) -button: to select the program start
delay of 1 - 24 hours. Select and start a program, that will start
automatically after the pre-selected lead time has elapsed.
5 EIN/AUS (power) -button: to switch on and off the power supply.
6 Child safety lock: press the button combination for a few seconds
to active or deactivate the child safety lock. All buttons, except the
power button, and the program selector switch are locked for the
operation.
7 Program selector switch: about the switch you select a wash
program. Consider the program details in the “Program table”.
8 Display:
- After the program has been started the remaining wash time is
displayed as [x:xx] hours and minutes.
- The start delay time is indicated, if set. The program starts after
[xx] hours.
- An icon indicates the activation of the child safety lock.
- An icon indicates the door lock, as long as the door lock is relea-
sed.
- The end of the program is displayed with [END].
- Error codes are displayed in case of failure.
Starting a Wash Program
Program table
NOTE:
The shown values are approximate and recommendations under standard conditions and therefore not binding. The consumption data can vary
depending on water pressure, water hardness, water inlet temperature, ambient temperature, type and quantity, as well as power supply and
selected additional options from the specied values.
Choose the right wash cycle according to the type, quantity and pollution. Always consider the instructions on the care label of your laundry.
Program Program selection information
Temperature
°C
Loading
kg
Time Rpm
Baumwolle Intensiv
(Cotton Intensive)
Wash cycle is recommended for cotton mix
fabric, linen, underwear, baby clothes or per-
sons with allergies.
cold / 20 / 30
/ 40 / 60 / 90
8.0
1:45 / 1:53
/ 1:53 / 2:00 / 2:01
/ 2:39
1400
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann WA 5834 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann WA 5834 in the language / languages: English, German as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info