552139
8
Zoom out
Zoom in
Previous page
1/9
Next page
8
03/2011
TIPS FOR ENERGY SAVING
Disconnect the plug if you do not use the device.
Do not install the device near stoves, heaters or other heat sources. In case of higher ambient
temperatures, the compressor will run more frequently and longer.
Ensure sufficient ventilation at the bottom and rear side of the device.
Never block any ventilation openings.
Allow warm dishes to cool down before putting them in the device.
Do not open the door longer then necessary.
Only set the temperature as low as needed. The ideal temperature in the fridge is 7°C.
It should be measured in the upper shelf, as far as possible in the front.
Always keep the condenser – metal grid on the rear side (if existing) – clean.
Make sure the door sealing is in good order for the door to close properly.
MAINTENANCE AND CLEANING
Cleaning and care
For hygienic reasons, clean the interior and accessory parts regularly.
WARNING
Always disconnect the plug or turn off/ unscrew the fuse before cleaning. Pull the plug and not the
cable.
Do not use steam cleaners for cleaning the device; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage the plastic parts. The device must be dry before
restarting operation.
Essential oils and organic solvents, such as the juice of lemon or orange skin, butanoic acid or
cleaning agents containing acetic acid can damage plastic parts. Prevent contact of any part with
such substances. Do not use abrasive cleaning agents.
Pls. do as follows:
Remove all food and keep covered at a cool location.
Use warm water and a mild detergent for cleaning the interior (including rear side and bottom).
Check the discharge opening.
After thorough drying, restart operation.
Clean the condenser - metal grid on the rear side (if existing) once a year, using a soft brush or
vacuum cleaner.
WARNING
Do not bend the cooling coils.
Do not use arenaceous abrasives.
Reverse the bulb
Lamp specifications: 220-240V, max. 15W
To turn off the device, set the temperature control to setting 0 - OFF.
Disconnect the plug or turn off the fuse!
Remove the screw from the lamp cover.
Press on the lamp cover and remove to the back.
Replace defect illuminant.
Reattach the lamp cover and fasten the screw.
Reconnect the device and turn on.
Repairs
WARNING
Servicing of electric devices must be conducted by qualified experts only. Incorrect or improper repairs
constitute a risk for the user and will void the warranty!
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann VS 108.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann VS 108.1 in the language / languages: English as an attachment in your email.

The manual is 0,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann VS 108.1

Bomann VS 108.1 User Manual - German - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info