552139
6
Zoom out
Zoom in
Previous page
1/9
Next page
6
03/2011
REVERSE THE DOOR OPENING
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door stop, the device must be disconnected from the power supply. Always unplug
the device first.
1. Use a flat bladed screw driver to remove the screw covers at the device top cover. Unscrew the
below screws and remove the device cover.
2. Tilt the device slightly backwards and block it in this position.
3. Loose the screws of the upper door hinge and remove the hinge along with the hinge pin.
4. Open the door a little, take it carefully of the lower door hinge and place it on a padded surface to
prevent it from scratches.
5. Turn the separate foot off and remove it and the lower hinge along with the foot and hinge pin by
unscrewing the screws. Unscrew the pin and put it at the opposite of the hinge.
6. Now screw the hinge incl. foot and the separate foot at the opposites of the device.
7. Put the door on the lower pin of the hinge and fix the door to the property position.
8. Mount the upper door hinge with the screws at the device opposite, upon you unscrewed the hinge
pin and put it in at the other side of the hinge again.
9. Afterwards the device top cover is to fix on again.
Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of
door is ensured.
STARTUP / OPERATION
Prior to first use
ATTENTION
After transport, the device should be left standing for 4 hours in order for the oil to be collected in the
compressor.
Nonobservance could cause damage to the compressor and hence result in failure of the
device. This would void your warranty claim.
Clean the interior of the device including all accessory parts located inside.
Connect the device to the mains supply
IMPORTANT
The device must be earthed properly. For this purpose the plug of the mains cable has been fitted
with the intended lead.
Contact an electrician if the plug does not fit in the wall socket.
In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting
the device.
Turning on
Turn on the device by connecting the plug to a wall socket and turning the temperature control, which
is located at the right side of the device interior. Please also refer to chapter “Settings“.
Settings
Setting 0 – OFF indicates the device is turned off.
Turn the temperature control clockwise, starting from this setting; the device will turn on automatically.
The Settings 1 MIN – 7 MAX regulate the inside temperature. When opening the door, the interior
lamp will turn on.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann VS 108.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann VS 108.1 in the language / languages: English as an attachment in your email.

The manual is 0,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann VS 108.1

Bomann VS 108.1 User Manual - German - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info