814358
18
Zoom out
Zoom in
Previous page
1/24
Next page
18
- Gap to the back approx. 5070 mm, to the
side walls and above the appliance each ap-
prox. min. 100 mm;
- Place the appliance so that the appliance door
can open without being impeded.
Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
The climate class can be found under
"Technical
data"
and on the rating label located in the interior
or on the appliance rear.
Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
- at locations with high humidity (e. g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e. g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e. g. garages).
- Do not expose the appliance any weather.
Leveling the appliance
Slight unevenness in the floor can be leveled out us-
ing the front feet.
Check whether the appliance is leveled horizontally.
If the appliance is not in balance, the feet must be
adjusted.
Electrical connection
WARNING:
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an electric
shock!
WARNING:
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION:
Do not switch on the appliance immediately after a
power interruption. Overloading of the compressor or
blowing of the fuse is possible.
Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
Intended use
The appliance is intended for commercial use and for
the purpose intended for it. It is suitable for storage,
presentation and sale of chilled beverages.
This cooling unit is not suitable for freezing food!
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter
“Cleaning and maintenance”
.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann KSG 7351 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann KSG 7351 in the language / languages: English, German as an attachment in your email.

The manual is 0.68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info