552180

Bomann KG 211 Manual

7
Zoom out
Zoom in
Previous page
1/14
Next page
7
04/2012
Electrical connection
• The kind of current (AC) and the voltage must be conform to the data of the rating label, located in-
side or outside on the back of the unit.
• In case of heavy voltage fluctuations, it is recommended to use an automatic alternating current reg-
ulator.
• The plug, together with the grounding conductor, must fit into the wall socket. The mains plug must
be freely accessible.
• If the appliance is brought in from the cold (temperature is not higher than +12 °C), you should wait
for two hours before connecting it to the mains.
• The appliance should not be connected to the mains until all packing and transport materials aren’t
removed. Once the appliance is unpacked, make sure that it is complete, that the body and the elec-
trical cord aren’t damaged.
It is forbidden to use a technically damaged appliance!
Mains cable
• Do not extend or roll up the cable during operation.
• Also, the cable must not be near the compressor on the rear side, since latter one gets hot during
operation. In case of any contact, the isolation would be damaged resulting in electric leakage.
• The use of extension cables is not recommended.
• Do not connect the device to the mains with wet hands.
• Install the device for the wall socket to be freely accessible.
REVERSE THE DOOR OPENING
If required, the door openings can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door stops, the device must be disconnected from the power supply.
WARNING! Turn off the appliance and pull the plug out of the electricity supply socket.
It is recommended that changing the opening direction of the doors should be done with a helper. You
will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the refrigerator horizontally.
Do the actions below in the order they are listed:
1. Remove the covers c from the body of the appliance and of the inner side of the door. Also
remove the upper bracket 6 together with the nut and washers and the spacer under the
bracket.
2. Remove the door of the refrigerator compartment. Remove the stopper 5 from the bottom of it.
On the other side of the door attach the stopper intended for doors that open on the left (you
will find it in the packet).
3. Remove the middle bracket 4 together with the washers on the axle and the plastic spacer.
4. Remove the freezer compartment door 3. Remove the bottom cover 1.
5. Remove the bottom bracket 2 together with the washers on the axle and the plastic spacer.
Unscrew the axle with the washers and screw it into the aperture provided on the other side.
6. Remove the bottom bracket 7 and in its place attach the other bottom bracket 2 together with
the washers on the axle and the plastic spacer. Fix this bracket 7 in place of the other bracket
2.
7. Remove the covers 8 from the partition separating the refrigerator compartment from the
freezer compartment and place them in the apertures on the other side.
8. Remove the covers 9 from the doors of the refrigerator compartment and the freezer com-
partment and place them in the apertures on the other side.
9. Hang the freezer compartment door on the axle of the bracket 2.
10. Turn the bracket 4 around 180° together with the washers on the axle and the plastic spacer,
transferring the washers to the axle on the other side of the bracket. Once the bracket is at-
tached to the freezer compartment door, fix it in place on the other side of the appliance.
11. Hang the refrigerator compartment door on the axle of the bracket 4.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann KG 211 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann KG 211 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann KG 211

Bomann KG 211 User Manual - German - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info