754673
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
NOTE:
You possibly need:
screw wrench, Phillips screwdriv-
er as well as a thin-blade screwdriver.
Remove the blind cap (1) and the hinge cover (2).
Loosen the screws (3), remove the door hinge (4)
and lift the appliance door.
Move the blind plug (5) of the appliance door to
the opposite side. Set the door aside safely.
Tilt the appliance slightly backwards and block it
in this position. Dismount the door hinge (6) with
its base by loosening the screws (7). Unscrew the
separate foot (8).
Move and fasten the door hinge (6) incl. base with
the screws (7). Screw in the separate foot (8) ac-
cordingly.
Put the appliance back in the upright position. Put
on the appliance door and fix it in the intended
position. Move and fasten the door hinge (4) with
the screws (3).
Replace the hinge cover (2) and move the blind
cap (1) into the exposed hole.
Check that the door is optimally aligned both vertical-
ly and horizontally to ensure a smooth opening and
closing of the door.
Startup / Operation
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for about four hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter “Cleaning and Maintenance”.
Starting the appliance
Connect the appliance to the power supply.
Operate the temperature control. See also the
section "Settings".
Settings
Setting [ OFF ] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [ 1 – 6 ] regulate the different val-
ues of the internal temperature.
Setting OFF: Off sate
Setting 1: Lowest setting (warmest inside temp.)
Setting 6: Highest setting (coldest inside temp.)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the power level to the
highest level first, until the appliance has reached the
desired operating temperature. Afterwards it is rec-
ommended to turn the control back to a medium set-
ting; correcting the temperature at a later point would
then be easier.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann KB 7235 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann KB 7235 in the language / languages: English, German as an attachment in your email.

The manual is 6,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info