814370
33
Zoom out
Zoom in
Previous page
1/48
Next page
33
A. Filling salt into the salt container (water softener)
Water softener
Water hardness varies regionally. If hard water is
used in the dishwasher, deposits form on the dishes
and kitchen utensils. The appliance is equipped with
a water softener, that removes lime and minerals
from the water by using water softening in the salt
container. Your local water authority can advise you
on the hardness of the water in your area.
Adjusting the salt consumption
The salt consumption can be adjusted according to
your water hardness and thus be regulated optimally.
Switch on the appliance.
Press the program selection button for more than
5 seconds, the setting mode is now activated for
approx. 60 seconds.
By repeatedly pressing the program selection
button the water hardness can be selected:
H1->H2->H3->H4->H5->H6. The indicator lights
show the selection (see below table).
The setting will be saved automatically after a few
seconds; alternatively, exit the setup via the pow-
er button.
Setting
Regeneration occurs every
X program sequence1)
Indicator light
lights brightly
Salt consump-
tion / cycle
°dH
Mmol/l
0 – 5 0 0.94 H1 No regeneration
0 g
6 – 11 1.0 2.0 H2 10
9 g
12 17 2.1 3.0 H3 (factory setting) 5
12 g
18 22 3.1 4.0 H4 3
20 g
23 34 4.1 – 6.0 H5 2
30 g
35 55 6.1 9.8 H6 1
60 g
°dH: German degree of hardness
1) Every cycle with a regeneration operation consumes additional 2.0 liters of water, the energy consumption
increases by 0.02 kWh and the program extends by 4 minutes.
Fill with salt
CAUTION:
Only refill the salt container when the salt warning
lamp is lighting.
During filling the salt container, salt and water can
escape. Start a program immediately after you
have filled the container to prevent corrosion.
Remove the lower basket and unscrew the lid of
the salt container.
Add about 1.5 kg of salt by using the supplied
funnel tube.
Full fill the salt container with water (just before
the first use).
Screw the lid firmly on again after filling the con-
tainer.
Depending on salt resolution, the warning lamp
usually disappears immediately after filling.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann GSPE 7413 TI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann GSPE 7413 TI in the language / languages: English, German as an attachment in your email.

The manual is 2.05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info