552048
17
Zoom out
Zoom in
Previous page
1/20
Next page
17
12/2011
Water Connection
The appliance is to be connected to the water mains using new hose sets and that old hose-sets
should not be reused.
The water pressure must be between 0.04 MPa and 1 MPa. Is the pressure lower or higher pls. con-
tact a technical specialist.
1. Pull the safety water hoses completely out from storage compartment located
at rear of dishwasher.
2. Tighter the screws of the safety hose tot he faucet with thread 3/4(inch).
3. Turn water fully on before starting the dishwasher.
About the Safety Supply Hose
The safety supply hose consists of the double walls. The hose's system guarantees its intervention by
blocking the flow of water in case of the supply hose breaking and when the air space between the
supply hose itself and the outer corrugated hose is full of water.
How to Disconnect the Safety Supply Hose
1. Turn off the water.
2. Unscrew the safety supply hose from the tap.
Cold Water Connection
ACHTUNG: The appliance is to be connected to the water mains using new hose sets and that
old hose-sets should not be reused.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fas-
tened tightly in place. If the water pipes are new or have not been used for an extended period of time,
let the water run to make sure that the water is clear. This precaution is needed to avoid the risk of the
water inlet to be blocked and damage the appliance.
Hot Water Connection
The water supply to the appliance can also be connected to the house hot water line (centralized sys-
tem, heating system), as long as it does not exceed a temperature of 60 C. In this case, the wash
cycle time will be shortened and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as those for the
connection to the cold water line.
WARNING: To avoid that water pressure remains in the inlet hose, please close the hydrant after
using.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of
40 mm, or let it run into the sink, making sure to avoid bending or
crimping it. Use the special plastic hinge that comes with the ap-
pliance . The top of the hose must be at a height between 500
mm (min) and 1100 mm (max).
The free end of the hose must not be immersed in water to avoid
the back flow of it.
How to Drain Excess Water From Hoses
If the sink is 1100 mm higher from the floor, the excess water in hoses cannot be drained directly into
the sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is
held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 meters; otherwise the cleaning effect of the dishwasher could be reduced.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann GSP 5707 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann GSP 5707 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann GSP 5707

Bomann GSP 5707 User Manual - German - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info