552048
16
Zoom out
Zoom in
Previous page
1/20
Next page
16
12/2011
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog
the spray arm jets and bearings.
To remove the upper spray arm, screw off the nut clockwise then remove the arm.
To remove the lower spray arm, pull out the spray arm upward. Wash the arms in
soapy and warm water and use a soft brush to clean the jets. Replace them after
rinsing them thoroughly.
How to keep your Dishwasher in Shape
8.
I
NSTALLATION
I
NSTRUCTION
The dishwasher should not stand on top of the water hoses or the electricity supply cable and the in-
stallation of the pipes and electrical equipments should be done by professionals.
WARNING
Electrical Shock Hazard! Disconnect electrical power before installing dishwasher.
Failure to do so can result in death or electrical shock.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the
sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain
hoses that can be positioned either to the right or the left sides to facilitate proper installation.
The power cord should be easily accessible.
The dishwasher can be installed under a working cover by following the steps of below pictures.
Leveling the Appliance
Once the appliance is positioned for leveling, the height of the dishwasher may be altered via adjust-
ment of the screwing level of the feet. In any case, the appliance should not be inclined more than 2°.
The max. adjusting height of the feet is 20 mm.
If the appliance is leveled correctly, it will be more stable and much less likely to move or cause vibra-
tions and noise while it is operation.
-
After Every Wash
After every wash, turn off the water supply to the
appliance and leave the door slightly open so that
moisture and odours are not trapped inside.
- Remove the Plug
Before cleaning or performing maintenance, al-
ways remove the plug from the socket.
- No Solvents or Abrasive Cleaning
To clean the exterior and rubber parts of the dish-
washer, do not use solvents or abrasive cleaning
products. Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the
interior, use a cloth dampened with water a n a lit-
tle vinegar, or a cleaning product mad e specifical-
ly for dishwashers.
-
When not in Use for a Long Time
It is recommend that you run a was h cycle with
the dishwasher empty and the n remove the plug
from the socket, turn off the water supply and
leave the door of the appliance slightly open. This
will help the door seals to last longer and prevent
odours from forming within the appliance.
- Moving the Appliance
If the appliance must be moved, try to keep it in the
vertical position. If absolutely necessary, it can be
positioned on its back.
- Seals
One of the factors that cause odours to form in the
dishwasher is food that remains trapped in the
seals. Periodic cleaning with a damp sponge will
prevent this from occurring.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann GSP 5707 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann GSP 5707 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann GSP 5707

Bomann GSP 5707 User Manual - German - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info