688080
18
Zoom out
Zoom in
Previous page
1/28
Next page
18
WARNING:
WARNING:WARNING:
WARNING:
When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odours to the outside.
The extracted air is normally vented verti-
cally. The extracted air can vented
through the wall units and the loft floor to
the roof ridge.
If there is a conduit under the wall units,
the extraction duct can be routed so that
the extracted air can be vented horizon-
tally through the wall.
Recirculation mode
Recirculation modeRecirculation mode
Recirculation mode
If you do not have a direct extraction vent to the out-
side; the hood can also work in recirculation mode
(i.e. without an extraction vent to the outside; the
filtered air is released back into the room). In this
case, activated carbon filter as described under “In-
stalling the activated carbon filter for recirculation
mode”, must be used.
Activated carbon filter are not supplied. You can or-
der the carbon filter from your dealer or in our online
accessories shop, www.bomann
www.bomannwww.bomann
www.bomann-
--
-germany.de
germany.degermany.de
germany.de. To
order, use the reference number found under “Tech-
nical Data”.
Assembly
AssemblyAssembly
Assembly
WARNING:
WARNING:WARNING:
WARNING:
When assembling or inserting the extraction filter
as well as the carbon filter, the appliance must not
be connected to the mains.
Failure to use the mounting fixtures may lead to a
risk of electric shock
risk of electric shockrisk of electric shock
risk of electric shock.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
Before mounting, check that the wall has sufficient
load capacity to bear the cooker hood.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE
NOTENOTE
NOTE:
::
:
Recomm
RecommRecomm
Recommendations for preparation work
endations for preparation workendations for preparation work
endations for preparation work
When installing, ask another person to assist.
Wear protective gloves to prevent injuries from
any sharp edges.
[05] [06] [07]
Determine the position of the device centrally
above the cooking area in accordance with the
specified safety distances.
Mark the holes required for wall mounting as
shown in the following drawing.
Specify in advance the extension length of the
shaft cover for the position of the bracket [06] at
the upper shaft end.
First, check the markings with a water balance.
Drill totally 7x mounting holes for the mounting
brackets and two more holes for the hood body
with approx. 8 mm diameter in the wall. Insert the
dowels [08].
Fasten the bracket hook [07] for the hood body
with three screws ST4x30mm [10].
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann DU 774 G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann DU 774 G in the language / languages: English, German as an attachment in your email.

The manual is 0,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info