688076
19
Zoom out
Zoom in
Previous page
1/28
Next page
19
Select the fume outlet and set the lever to the
appropriate position, see “Selecting the fume out-
let”.
Mounting at the wall
Mounting at the wallMounting at the wall
Mounting at the wall
Mark the necessary holes for the wall mounting by
using the supplied drill template and check them
with a spirit level.
Drill two mounting holes Ø 8 mm into the wall and
insert the dowel pins (1). Then turn in the screws
(2) so far that they project approx. 4 mm out of the
wall.
Suspend the hood and tighten the screws through
the hood body. Check the secure fitting and hori-
zontally position.
Mounting below the wall u
Mounting below the wall uMounting below the wall u
Mounting below the wall unit
nitnit
nit
Hold the hood to the specified cabinet position
and draw the drilling points from the inside of the
unit corresponding to the four screw holes. Check
them with a spirit level.
For extraction mode, you must also create a feed
through of approx. Ø 130 mm in the base of the
unit.
If the mains cable is fed through the unit, a feed
through also must be provided.
Drill four mounting holes of Ø 4 mm through the
base of the unit. Screw in the appliance with the
screws including washers (3) under the wall unit
and tighten the nuts (4) through the hood body.
For extraction mode insert the connecting piece
with non-return valves (5) from above onto the air
outlet. Thereto a flexible extraction hose (not sup-
plied) with an inner diameter of Ø 120 mm must
be fitted and connected to the outside by an ex-
traction vent.
For recirculation mode close the air outlet by put-
ting on the cover (6).
Reinstall the aluminum grease filter.
Installing the activated carbon filter mat for recircul
Installing the activated carbon filter mat for recirculInstalling the activated carbon filter mat for recircul
Installing the activated carbon filter mat for recircula-
a-a-
a-
tion mode
tion modetion mode
tion mode
Remove the aluminum
grease filter (1).
Insert the previously fitted
carbon filter mat parts onto
the grease filter and fix the mat parts each with
two metal struts (2) (supplied with carbon filter
mat).
Reinstall the aluminum grease filter with fixed
carbon filter mats.
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an electric
electric electric
electric
shock
shockshock
shock!
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann DU 623.3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann DU 623.3 in the language / languages: English, German as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info