814346
26
Zoom out
Zoom in
Previous page
1/32
Next page
26
Tips for energy saving
Disconnect the appliance from the power supply if
it isn’t in use.
Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
Ensure enough ventilation at the bottom and rear
side. Never block ventilation openings.
Place all shelves, racks or drawers (depending on
the model) in their original position.
Adjust the temperature not colder than necessary.
Allow warm food to cool before placing it in the
appliance.
Open the appliance door only as necessary.
Defrost the unit regularly (model dependent).
The seal of the appliance door must be complete-
ly intact, so that the door closes properly.
Cleaning and maintenance
WARNING:
Always disconnect the appliance from the power
supply before cleaning and user maintenance.
Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
The unit must be dry before restarting operation.
CAUTION:
Do not use a wire brush or other sharp, abrasive
items.
Do not use any acidic or abrasive detergents.
Do not damage the refrigerant circuit.
Cleaning the appliance including interior
To keep dirt and germs at bay, clean the appliance
regularly!
First clear out the contents of the appliance and
store it in a cool place. Remove all moving parts
such as shelves or drawers.
Clean the interior of the appliance, the exterior
surfaces and the accessories with lukewarm wa-
ter and a mild cleaning agent; or with a clean,
damp microfiber cloth without cleaning agent.
Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
After everything has dried thoroughly, you can put
the appliance back into operation.
Depending on the model:
At least once a year,
wipe off the dust that has accumulated on the rear
wall of the unit and on the condenser (metal
grille). Use a soft brush or a vacuum cleaner for
this purpose.
Cleaning / replacing the door seal
Regularly check the seal for dirt, damage and air
tightness!
Checking the seal for air tightness
Clamp a thin piece of paper at various points for
testing. The paper must be equally difficult to pull
through at all points.
Cleaning the gasket
Clean the gasket with clear water only!
CAUTION, grease and oil makes the seal porous
and brittle. Wipe up grease or oil immediately with
a damp, clean cloth.
Replacing the seal
Remove the contents of the appliance and, if
necessary, defrost the unit. Pay attention to how
the old gasket is attached. Most gaskets are only
plugged in.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann DTR 353.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann DTR 353.1 in the language / languages: English, German as an attachment in your email.

The manual is 1.04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info