Manual Bomann cb 2002 (page 19 of 54) (English, German, Dutch, Italian)

361458

Zoom out

Zoom in

1/54

ENGLISH

Using the rotating dial you can

adjust the degree of grinding

to eight different levels from 1

(very ﬁ ne) to 8 (very coarse). The

factory setting is suitable for

most cases.

The ﬁ ner the coffee is ground,

the more intense is its taste.

However, percolation then takes

longer.

How to alter the setting:

• Remove the lid from the coffee bean container (1).

• The rotating dial for adjusting the degree of grinding

is located on the left-hand front side of the coffee

bean container.

• Make a cup of coffee using coffee beans.

• With the coffee meal running, press the rotating head

downwards and carry out the required adjustment.

The changed settings only become noticeable after the

preparation of two to 3 cups of coffee.

Self-Test

When the machine is

switched on it auto-

matically carries out a

self-test. The MENU/OK/

MEMORY button ﬂ ashes.

At the same time a clea-

ning cycle is performed,

with the residual water

(approx. 20-50ml) being

rinsed out of the machine.

When the MENU/OK/

MEMORY button lights up, the machine is ready for use.

The adjacent symbols then appear in the display (16).

Preparing Coffee

• Position the coffee spout (13) at the right height.

• Place a coffee cup under the coffee spout. The

machine must be in normal mode, as shown by

the MENU/OK/MEMORY button lighting up. If the

machine is in steam mode it has to be switched back

to normal mode.

• Press the MENU/OK/MEMORY button, or the

BACK button. You can then take over or change the

following presets:

Coffee Beans/Coffee Powder

Press the

button if you would like to switch bet-

ween the “coffee beans” and “coffee powder” settings. If

the “coffee powder” setting is selected the

button

lights up.

Normal Cup/Large Cup

Press this button

if you would like to switch

between the normal cup and large cup settings. The cup

symbol in the display (16) changes.

Stored Aroma Setting/New Selection

• Press the MENU/OK/MEMORY button if you do not

want to use the factory settings.

If the „M” symbol is not shown you can change the set-

tings without storing them. For further information please

see the section on “Programming Presets“.

One Cup/Two Cups

• Place one coffee cup under each of the two openings

of the coffee spout (13). Select the ﬁ lling quantity

with the

button.

• Press the START button twice.

• Now 2 cup symbols are shown in the display, either

“two normal cups” or “large cups”, depending on the

pre-selection.

Stopping Percolation

In order to stop percolation, press the

button.

Automatic Rinsing

After 10 cups have been prepared the machine is auto-

matically rinsed. This is shown by the buttons MENU/

OK/MEMORY and START lighting up simultaneously.

Please empty the drip collector (10) regularly.

Preparing Hot Water

Caution! Danger of scalding from steam and hot wa-

ter! Never point the steam or hot water jet at yourself

or others!

The device must be set to

normal mode.

• Place a heat-resistant

vessel under the hot

water/steam nozzle

(14).

• Turn the hot water/

steam switch (9) care-

fully in an anticlockwi-

se direction.

Hot water ﬂ ows out of the hot water/steam nozzle. The

further you turn the switch away from the OFF position

in an anticlockwise direction, the greater the quantity of

water that ﬂ ows out.

• When the vessel is full, turn the hot water/steam

switch (9) back to the OFF position.

Producing Steam and Foaming Milk

Caution! Never point the steam or hot water jet at

yourself or others! There is a danger of scalding from

steam and hot water!

Use the steam nozzle (14) to foam milk for cappuccino or

heat up other drinks. If you would like to foam milk, ﬁ ll a

vessel one third full with cold milk. If you use low fat milk

the foam you obtain will be more stable.

05-KAV 2936 GB 19 03.12.2004, 12:13:24 Uhr

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bomann cb 2002 in the language / languages: English, German, Dutch, Italian as an attachment in your email.

The manual is 7,79 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bomann cb 2002 Manual

Product: