814746

Bomann BSS 6000 CB Manual

45
Zoom out
Zoom in
Previous page
1/78
Next page
BSS6000CB 17.10.17
45
Notes for Wet Vacuuming and
for Vacuuming with Shampoo
CAUTION:
• Do not ll foaming shampoos into the shampoo tank!
• Always remove the permanent lter when vacuuming
liquids.
• Before the cleaner is used again for dry vacuuming, all
components must be dry.
Immediately switch off the appliance in the following
situations:
• During foaming
• If liquid escapes
• When the vessel is full.
• When the appliance falls over.
NOTE:
• The collection vessel can hold approx. 10 litres of liquid
(without foaming).
• If foam should form in the collection vessel, then the
maximum capacity is only 1.5 litres!
• When the vessel is full the oat valve closes the suction
aperture and the motor runs at a higher speed. Switch
the appliance off immediately and empty it.
Operation
Preparation
1. Unwind the lead completely.
2. Check if the mains voltage that you want to use matches
the information on the rating plate.
CAUTION:
Take note of the range limited by the length of the cable!
3. Open the locking mechanisms.
4. Remove the engine housing using the handle.
5. If the protective lter has not yet been mounted, attach
it as described in chapter “Notes on Use” “Protective
Filter Made of Foam”.
CAUTION:
Check that the protective lter ts properly.
Dry Vacuuming
1. Attach the permanent lter as described in chapter “Notes
on Use” “Permanent Filter”.
2. Attach the motor housing.
3. Close the locking mechanisms.
4. Attach the wet / dry brush or the crevice nozzle to the
suction pipe or directly to the suction hose.
5. Connect the mains plug to a properly installed earthed
socket.
6. Set the On / Off switch to I.
7. Vacuum at a steady speed. There is no need to exert
pressure.
Wet Vacuuming
1. Disconnect the mains plug from the socket.
2. Remove the permanent lter.
3. Attach the motor housing.
4. Close the locking mechanisms.
5. Attach the wet / dry brush to the suction pipe or directly to
the suction hose.
6. Connect the mains plug to a properly installed earthed
socket.
7. Set the On / Off switch to I.
Vacuuming with Shampoo
NOTE:
• Dose as indicated on packaging or instruction leaet.
• Furthermore, refer to the instructions for carpets or
upholstery in order to avoid damaging them.
• Test your appliance beforehand at an insignicant spot.
Installation of the Shampoo Accessory
1. Disconnect the mains plug from the socket.
2. Attach the shampoo or upholstery brush to the suction
pipe or directly to the suction hose. Insert the hose of the
brush into the connector of the shampoo hose.
3. The bottom end of the shampoo hose must be connected
to the engine housing. You find symbols at the shampoo
house and engine housing (  + ). Attach the shampoo
hose to the engine housing in such a way that the sym-
bols are facing each other. Tighten the shampoo hose by
turning it clockwise.
4. There is another hose at the shampoo tank. Attach it in
the same way as previously described.
NOTE:
Make sure the shampoo hose has no kinks!
Handling
1. Remove the permanent lter.
2. Attach the motor housing.
3. Close the locking mechanisms.
4. Fill the shampoo tank with water and cleaning shampoo.
Do not ll more than 3 L. There is a marking on the
shampoo tank.
5. Connect the mains plug to a properly installed earthed
socket.
6. Set the On / Off switch to II.
7. Use the spray device lever on the suction hose to release
the shampoo.
Dismantling of the Shampoo Accessory
1. Disconnect the mains plug from the socket.
2. In order to remove the brush, press down the bottom of
the connector at the shampoo hose. Remove the hose.
3. Remove the hose ends from the engine housing by turn-
ing them counterclockwise.
… 45 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann BSS 6000 CB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann BSS 6000 CB in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2.2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info