814744

Bomann BS 6027 A CB Manual

48
Zoom out
Zoom in
Previous page
1/86
Next page
BS6027ACB_IM 05.06.19
48
Nozzle Attachments (22, 23 and 24)
There are two different ways for connecting these nozzles
to the appliance:
Connection at the Hand Unit
• Note the recesses on the crevice nozzle and on the large
brush nozzle.
• Plug one of the nozzles into the port on the handset. It
must engage audibly.
• To release the respective nozzle, press the release but-
ton PUSH (16) while pulling it out at the same time.
Connection to the Suction Pipe
At the lower end of the suction pipe, you will nd the same
plug connection as on the handset. Mount / dismount the
nozzle as described above.
Crevice Nozzle
For vacuuming dirt from corners, joints and small gaps.
Large Brush Nozzle / Upholstery Brush
This nozzle is suitable for removing dust from sensitive
surfaces such as upholstery, furniture or curtains. The brush
head is rotatable.
Mini Special Brush
This special nozzle is particularly well suited for the gentle
cleaning of smaller surfaces such as keyboards.
Assembly the Wall Holder
Please take a look at the image of the wall bracket on
page 3.
WARNING:
Make sure beforehand whether there are cables in the
wall which could be damaged!
CAUTION:
Place the wall holder so that the appliance is not exposed
to direct sunlight or other heat sources.
NOTE:
If you would like to simultaneously use the wall mount as
a charging station, there must be a power outlet nearby.
1. Measure the height for the wall holder. Hold the vacuum
cleaner against the wall with the suction pipe and the
oor nozzle installed.
2. Plug the accessory holders onto the designated slots
(18, 19, 21) of the wall bracket.
3. On the back of the wall bracket, you will see two slotted
holes below one another. Draw two drill holes on the wall
at the distance of the slotted holes (about 154 mm).
4. Drill the marked holes and insert the dowels into the wall.
5. Fit the screws in such a way that the head sticks out a
few millimetres.
6. Install the wall bracket via the slotted holes using the two
screws. Ensure the screws are seated at the upper stop
of the slotted holes.
NOTE:
The wall bracket should be as close to the wall as pos-
sible. You may set the correct distance from the wall by
screwing the screws in or out.
7. You may attach the nozzles to the accessory holders on
the side.
8. Insert the power supply plug into the connector socket on
the upper side of the wall bracket (17).
Charging the Rechargeable Battery
CAUTION:
Do not charge the rechargeable battery unsupervised.
1. Turn off the appliance.
2. Connect the power adapter with the connection
socket (5). If you have prepared the wall holder as a
charging station, suspend the appliance from the wall
holder.
3. Connect the power adapter to a certied wall socket.
Charge the appliance for approx. 4 hours before rst-
time use.
NOTE:
• The indicator lights show the state of charge of the
rechargeable battery. (25 %, 50 %, 75 %, 100 %)
• The appliance has electronic charge control, which
prevents overcharging.
• Charging is completed when all 4 indicator lights
are lit. The electronics will switch to trickle charging.
Nevertheless, do not leave the appliance plugged-in
permanently to prevent possible damage to the
rechargeable battery.
• In case the appliance is removed from the charging
station or disconnected from the power adapter, the
indicator lights go out.
• It is normal for the appliance to heat up during
charging.
4. Disconnect the power adapter from the outlet once the
rechargeable battery has been charged completely.
NOTE:
Even when switched off, the rechargeable battery dis-
charges continuously. If the appliance is out of use for a
longer period of time, charge the rechargeable battery at
least once every 4 to 6 weeks.
Using the Appliance
You can use the appliance as a oor vacuum cleaner or as
a handheld and upright vacuum cleaner (basic appliance).
1. Disconnect the appliance from the power adapter.
… 48 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann BS 6027 A CB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann BS 6027 A CB in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info