573543

BodySculpture BE-6910 Manual

16
Zoom out
Zoom in
Previous page
1/21
Next page
13
2.0 Displays during training
2.1. Time, Distance, Calories and WATT start counting up from zero when the training starts without function
presetting. (fig. 8)
2.2. Before training starts or during training, the profile height could be adjusted (resistance level change) in
MANUAL, PROGRAM, and USER training mode.
2.3. If there is any function preset before training, it starts to counting down when the training starts. (fig.9)
(fig. 9) (fig. 10)
3.0 Displays when the training is stop
3.1 Press START/STOP button during training can interrupt the training. All function data will stop counting.
(fig.10 )
3.2 The preset function data will show the figure after counting down for a while. Press START/STOP button
again to have the function counting down from the stop point.
3.3 The function which was counting up from zero will stop after pressing START/STOP button, and counting up
again from the stop point after pressing START/STOP button again.
4.0 Target Heart Rate control training
4.1.The monitor will keep tracking your current heart rate figure compared to the preset target and make
adjustment to the resistance level during training.
(fig. 11) (fig. 12)
4.2. If the current heart rate is less than the target, the resistance level will be increased (fig. 11) per level in every 30
seconds till the resistance is achieved to the maximum.
4.3. If the current heart rate is over the target, the resistance level will be decreased (fig. 12) immediately and keep
decreasing one level in every 15 seconds till the resistance is dropped to level one.
4.4. When the training resistance is dropped down to level one but the heart rate figure is still higher than the target for
1 minute, the monitor will stop and have beep alarm to remind you as a protection solution.
4.5. If the training mode you select is MANUAL, or PROGRAM, or USER, when you preset a target heart rate figure, the
monitor will have visible blinking alarm when the current heart rate figure is over than the target but without any
resistance level adjustment feature.
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BodySculpture BE-6910 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BodySculpture BE-6910 in the language / languages: English as an attachment in your email.

The manual is 1,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info