640549

Blomberg WM 67120 NBL00 Manual

22
Zoom out
Zoom in
Previous page
1/40
Next page
22 EN
Special programs
For specific applications, you can select
any of the following programs:
• Soak
This wash cycle is used for heavily soiled
items when you want to pre-treat them.
Cycle soaks the laundry in a relatively
high amount of warm water for two
hours approximately. You can use full
load and HE “High efficiency” main
wash detergent for this cycle. Use half
of the recommended detergent dose
for the load amount to be soaked. This
program ends with a 600rpm spin cycle.
• Spin/Drain
“Drain” is used to discharge the water
without spinning the clothes. “Spin” is
used to spin dry the load with selected
spin speed. Spin and Drain may be
selected as two individual program
cycles in this model.
C
You should select a lower spin
speed for delicate wash items.
Spin speed selection
Whenever a new program is selected,
the maximum spin speed of the selected
program is shown on the display if “spin”
button is pressed once.
To decrease the spin speed, press the
“Spin” button. Spin speed decreases
gradually. Then, no spin option is shown
respectively.
No spin is shown with “” symbol.
C
You can use “No spin” function in
order to drain the water without
spinning at the end of the program.
“No spin” selection is available for all
wash cycles.
In order to protect your clothes, your
washer will not spin above 800 rpm on
permanent press cycles and 600 rpm on
delicates, wools and hand wash cycles.
For Cottons/Regularwash cycles,
spin speed can be adjusted between
800-1200 rpm (including no spin).
For wools, delicates and hand wash
cycles, spin speed can be adjusted
between No spin - 600 rpm.
For permanent press cycles, spin speed
can be adjusted between No spin - 800
rpm.
Auxiliary functions (Options)
Auxiliary function selection keys
Select the required auxiliary functions
before starting the program.
Auxiliary function selection
You should not select Quickwash
and Superwash at the same time.
Superwash will be cancelled and
Quickwash will remain active in such a
case.
Auxiliary function that is not compatible
with the program cycle cannot be
selected.(see “Cycle Selection Table”).
Quick wash
This function can be used for Cotton/
RegularwashandPermanentPress
programs. It decreases the washing
times for lightly soiled items.
Super wash
This function can be used for all wash
cycles except for “Soak”. It increases
washing times for heavily soiled items for
good wash results. Washer will only take
cold water when this option is chosen.
Extra rinse
With this function, you can increase the
number of current rinsing steps. Thus,
sensitive skins’ risk of being affected by
the remaining detergent on the clothes
will be decreased.
Time display
The display shows the time remaining for
the program to complete while a cycle is
running. Time is displayed in hours and
minutes as “01:30”.
C
Programdurationmaydifferfrom
the values in the consumption table
subject to the changes in the water
pressure, water hardness and
temperature, ambient temperature,
type and amount of laundry, auxiliary
functions selected, and changes in
the supply voltage.
Time delay
With the “Time delay” function you can
delay the program start up to 24 hours.
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg WM 67120 NBL00 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg WM 67120 NBL00 in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info