640549
12
Zoom out
Zoom in
Previous page
1/40
Next page
12 EN
electric shock. Always unplug the
cable by grasping the plug, not the
cord.
B
WARNING – Do not use wet hands
when plugging/unplugging the power
cable.
Power supply and circuit
Connect the clothes washer to the
junction box supplied. Junction box
must be connected to an earthed outlet
protected by a fuse of suitable capacity.
Important:
•Mainsconnectionshouldcomplywith
national regulations.
•Thevoltageandmaximumtotal
current are specified in the section
“Specifications”.
•Theappliancemustnotbedirectly
connected to the mains in case of
absence of junction box.
•Connectionviaextensioncordsor
multi-plugs should not be made.
B
WARNING - A damaged power
cable must be replaced by a qualified
electrician.
B
WARNING - The appliance must not
be operated unless it is repaired!
There is the risk of electric shock!
15 Amp. Fuse or circuit breaker,
208-240 volt, 60 Hz, grounded,
alternating current
Properlygrounded3-prongreceptacle
and junction box to be located so the
power supply cords are accessible when
the washer is in installed position.
Water Supply Connection
Your washer comes with both cold and
hot water connections. Connect the
blue marked cold water supply hose to
the cold water inlet valve/faucet and the
red marked hot water intake hose to the
hot water inlet valve/faucet. Screw the
connecting bolts by hand and tighten
the connection properly using a plier.
Over tightening may cause damage on
bolted connection.
A
WARNING – Be sure that the water
connection of this washer is handled
by a qualified service technician or a
plumber.
The washer has two bolted ½’’ water
supply hoses and ¾’’ female hose
connections that can be connected to
¾’’ hot and cold water faucets.
A
WARNING – Be sure that water
supply hoses are not crushed and
they have no kinking, bulges or cuts
before the water connection.
A
WARNING – Be sure that there
are rubber seals located on the
hose connections. These seals
and adjustable bolts ensure a safe
connection without leaking. After
the water connection is done, turn
on both water faucets slowly and
completely to check any water leaks.
The water pressure must be between
15-145 psi (1-10 bar) for the proper
operation of this washer. 1 bar
corresponds to more than 2.1 US
gallons (8 liters) per minute flow rate
with a fully open faucet. Water inlet
hoses and valves should withstand a
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg WM 67120 NBL00 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg WM 67120 NBL00 in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info