581467
36
Zoom out
Zoom in
Previous page
1/56
Next page
34
Fastening the hose holder:
1. Pull the holder included in delivery
over the end of the hose.
2. Hand the drain hose with the holder
over the edge of the basin or tub and
secure it from sliding off – e.g. by fas-
tening it with a chain around the wa-
ter tap.
Permanent connection to a siphon trap:
A
A qualified plumber should attach the
hose to prevent the hose from slipping
off. There is a risk of flooding.
Electrical connection
Connect the appliance to a properly in-
stalled earthed outlet, which is protected
by a fuse of adequate capacity.
Important:
The connection must conform to the
applicable regulations in your country
and those set by your electricity
board.
The power cable plug must be accessi-
ble after installation.
Voltage and rated fuse protection is
specified on the type plate located on
the back of the loading door.
The stated voltage must match with
your mains voltage.
Connection by extension cables or
trailing sockets is not permitted.
B
A damaged power cable must be re-
placed by a qualified electrician.
Unless the appliance has been re-
paired it must not be operated! Risk of
electric shock!
The First Use
3
Refer to the section on "Troubleshoot-
ing" if the machine can't be switched
on.
To flush out any remaining test water, the
first washing cycle should be run without
any laundry.
1. Open water tap fully. Check if hoses
are firmly attached.
2. Check that the drum is completely
empty; close the loading door.
3. Add a small amount of detergent to
the second compartment; close deter-
gent dispensing drawer.
4. Press >On/Off<18 button. Some infor-
mationa appears in the display after a
few seconds.
5. Set programme selector to >Hot wash/
Coloured 95 °C< (see "Programmes").
The spin speed indicator should be set
to maximum speed if necessary press
the >Spin<21 button.
6. Press >Start/Pause<20 button.
A
In case of abnormal sounds or leakage
of water: Press >On/Off<18 button,
close water tap and pull mains plug
out of the socket. Check to see that all
transit bars have been removed and
the hoses are properly connected.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg WAF 1300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg WAF 1300 in the language / languages: English, German as an attachment in your email.

The manual is 2,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info