55
Rehingeing the door
The side at which the door opens can be changed from the right side (factory adjustment) to the left
side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance may not be connected to the
mains. Remove plug from the mains beforehand.
Tilt the appliance slightly towards the rear and drop it securely.
Pull off the ventilation grille, which is a clip-on fit.
Unscrew the door hinge screws (K) and take the door bearing (1)
downwards out of its cavity.
Open the door a little way and take it out downwards.
Unscrew the upper pin (2) and screw it into place on the opposi-
te side.
Fit the door into the upper pin (2) and close it.
Insert the pin of the door bearing (1) into the left hand cavity
and screw the bearing firmly into place with the screws (K).
Unscrew the handle. Refit it on the opposite side; holeswhich are
not used must be masked with the plastic plugs previously remo-
ved from the opposite side.
☞
☞
☞
☞
☞
☞
☞
☞
