581387
6
Zoom out
Zoom in
Previous page
1/31
Next page
6
Front panel controls
Volume
Balance
S1MP3 In S2 S4 S5S3 USB
TrebleBass
Speaker B DirectPhonesOn / Off
azur 351A
Integrated Amplifier
1
Power On/Off
Switches the unit on or off.
2
MP3 Input
This source input allows you to connect a portable audio device such
as an MP3 player, plugged into either the rear panel Phono/RCA input
pair (labelled ‘S1’) or the front panel 3.5mm stereo-jack input (labelled
‘MP3 In’).
Press the S1 button on the front panel to select the input, or insert a
device into the front panel socket which automatically selects the input
and overrides the rear Phono/RCA sockets.
3
Phones
Allows for the connection of headphones with a ¼” jack plug connector.
Headphones with an impedance of between 32 and 600 ohms are
recommended. When the headphones are connected, the output to the
loudspeakers is switched off.
4
Speaker B
Turns on/off the secondary set of loudspeaker terminals on the back
panel. This can be used for listening to an extra set of loudspeakers in
another room.
Please note that care should be taken when selecting if two loudspeakers
are going to be used on each channel. If the combined resistance
measured on the loudspeaker terminals is too low the amplier may not
switch out of Standby mode until a suitable load resistance is detected.
Note: When using two pairs of speakers, use speakers with a nominal
impedance of between 6-8 ohms each.
5
Direct
This control gives the audio signal a more direct path to the power
amplier stage of your amplier, bypassing the bass and treble control
circuits for the purest possible sound quality.
6
Bass and Treble
These controls allow subtle adjustments to the tonal balance of the
sound. In the central position these controls have no effect. They only
modify the sound through your loudspeakers and do not affect the
signals sent through the Rec Out connections. With a well-produced
CD and a good system, the tone controls are unnecessary and can
be switched out by the ‘Direct’ switch. If the musical recording is of
poor quality or other factors are affecting the sound quality, it may be
necessary to adjust the tone controls to compensate.
7
Infrared sensor
Receives IR commands from the supplied Azur remote control. A clear,
unobstructed line of sight between the remote control and the sensor
is required.
8
Volume
Use to increase or decrease the level of the sound from the outputs of
the amplier. This control affects the level of the loudspeaker output,
the preamp output and the headphone output. It does not affect the
Rec Out connections. It is advisable to turn the Volume control fully anti-
clockwise before switching the amplier on.
9
Balance
This control allows you to adjust the relative output levels of the left and
right channels. In the central position the output from each channel is
equal. This control only modies the sound through your loudspeakers
– it does not affect the signals sent through the Rec Out connections.
10
S1-S5 Source inputs
Push the appropriate input selection button to select the source
component that you wish to listen to. The signal selected is also fed to
the Rec Out sockets so that it may be recorded. The input should not be
changed whilst recording.
11
USB
This source input allows connection of a personal computer via USB.
1 2 3 4 5 6 7 8 9 10 11
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg GSN 1370 A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg GSN 1370 A in the language / languages: English, German as an attachment in your email.

The manual is 7,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info