315942
6
Zoom out
Zoom in
Previous page
1/12
Next page
6
Electrical safety
#
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
the voltage on the rating plate.
If the supply cord is damaged, it must
be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not use the appliance to vacuum
any electrical appliances while they
are plugged in.
Features
1. On/off switch
2. Release button
3. Clogged filter indicator
4. Dust bowl
Fig. A
5. Brush tool
6. Crevice tool
7. Bowl adaptor
8. Floor head
9. Hose
10. Blow adaptor
11. Tubes
12. Tool adaptor
13. Blow diffuser
14. Small inflator adaptor
15. Medium inflator adaptor
16. Large inflator adaptor
Assembly
Warning! Make sure that the appliance
is switched off and unplugged.
Fitting the accessories (fig. A - G)
Fitting the accessories for vacuuming
The accessories provided can be used in
various combinations, depending on the
task (fig. B):
a. General vacuuming / dusting
b. Vacuuming in confined spaces
c. Vacuuming stairs
d. Vacuuming upholstery
e. Vacuuming in corners
f. Vacuuming carpeted floors
g. Vacuuming hard floors
The brush tool (5) and the crevice tool (6)
are stored at the underside of the
appliance. To fit an accessory, proceed
as follows (fig. D):
Take the accessories from the
appliance.
Insert the appropiate accessory into
the front of the appliance.
Fitting the accessories for blowing
and inflating
The accessories provided can be used in
various combinations, depending on the
task (fig. C):
a. Blowing
b. Inflating
To increase your working range, it is also
possible to fit the tubes to the end of the
hose.
To fit the accessories, proceed as follows
(fig. E & F):
Open the exhaust filter holder (17).
Insert the blow adaptor (10) into the
opening (18). Make sure it fits snug
against the rear of the appliance.
Insert the other accessories as shown.
For inflating purposes, fit an inflator
adaptor to the hose (fig. G):
Align the tab (19) on the adaptor with
the hole (20) in the hose end.
Push the adaptor on the hose until it
clicks into place.
To remove the adaptor, lift up the tab
and pull the adaptor off the hose.
Use
Warning! Before connecting to the
power supply, make sure that the
appliance is switched off.
Switching on and off
To switch the tool on, set the on/off
switch (1) to position I.
To switch the tool off, set the on/off
switch to position O.
Warning! Make sure the accessories are
securely attached before switching on.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker vh 780 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker vh 780 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info