709484
13
Zoom out
Zoom in
Previous page
1/116
Next page
13
ENGLISH
(Original instructions)
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Warning! Before proceeding, release the bail bar to turn
mower off and wait for the blade to stop .
Problem Possible solution
Mower doesn’t run when
bail handle is activated.
Check to make sure mower is properly plugged
in and that the button on switch box is being
completely depressed before pulling the bail
handle.
Release bail handle to turn mower off. Remove
safety key and battery pack, turn mower over
and check that blade is free to turn.
Motor stops while mowing. Release bail handle to turn mower off. Unplug
mower. Turn mower over and check that blade
is free to turn.
Raise cutting height of wheels to highest posi-
tion and start mower.
Avoid overloading the mower. Slow down the
cutting pace, or raise the cut height.
Mower runs but cutting
performance is unsatisfac-
tory,
Release bail handle to turn mower off. Unplug
mower. Turn mower over and check:
u Blade for sharpness - Keep blade sharp.
u Deck and discharge chute for clogging.
Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
Mower is too hard to push. Release bail handle to turn mower off. Unplug
mower. Raise cutting height to reduce deck
drag on grass. Check each wheel for free
rotation
Mower is abnormally noisy
and vibrates.
Release bail handle to turn mower off.
Unplug mower. Turn mower on side and
check blade to ensure it has not been bent or
damaged. If blade is damaged, replace with
a BLACK+DECKER replacement blade. If
the underside of the deck is damaged, return
mower to a BLACK+DECKER Authorized
service center.
If there is no visible damage to the blade and
the mower still vibrates:
u Release bail handle to turn mower off.
u Unplug mower.
u Disassemble entire blade assembly as
described in the “Removing and installing
blade” section.
u Remove any debris and clean each piece.
u Replace each piece as described in the
“Removing and installing blade” section.
If mower still vibrates, return the mower to
an authorized BLACK+DECKER authorized
service center.
Mower not picking up
clippings with bag.
Chute clogged. Release bail handle to turn
mower off. Unplug mower. Clear chute of grass
clippings.
Raise cutting height of wheels to shorten length
of the cut.
Bag full. Empty bag more often.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled, reducing demand for raw materials. Please
recycle electrical products and batteries according to local
provisions. Further information is available at
www.2helpU.com
Technical data
LM2000
Voltage
Vac 230V
Power input
W 2000
No-Load Speed
min
-1
3500RPM
Impedence
Z
MAX
0.4103
Weight
kg
25.46
Hand/arm weighted vibration value:
= <2,5 m/s
2
, uncertainty (K) = 1,5 m/s
2
.
L
PA
(sound preasure) 85 dB(A)
uncertainty (K) = 2,5 dB(A)
EC declaration of conformity
MACHINERY DIRECTIVE
OUTDOOR NOISE DIRECTIVE
%
LM2000 lawn mower
Black & Decker declares that these products described under
"technical data" are in compliance with:
2006/42/EC, EN 60335-1:2012 + A11:2014,
EN 60335-2-77:2010
2000/14/EC, Lawn Mower, L < 50cm, Annex VI,
DEKRA Certication B.V., Utrechtseweg 310, ED Arnhem
Netherlands
Notied Body ID No.: 0344
Level of accoustic power according to 2000/14/EC (Article 12,
Annex III, L < 50cm, cm):
L
WA
(measured sound power) 95 dB(A)
uncertainty (K) = 1,0 dB(A)
L
WA
(guaranteed sound power) 96 dB(A)
These products also comply with directive 2014/30/EU and
2011/65/EU. For more information, please contact Black &
Decker at the following address or refer to the back of the
manual.
The undersigned is responsible for compilation of the technical
le and makes this declaration on behalf of Black & Decker.
R. Laverick
Director of Engineering
Black & Decker Europe, 210 Bath Road, Slough,
Berkshire, SL1 3YD
United Kingdom
26/08/2016
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker LM2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker LM2000 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 6,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info