497046
7
Zoom out
Zoom in
Previous page
1/76
Next page
7
ENGLISH
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
Do not store in locations where the
temperature may exceed 40 °C.
Charge only at ambient temperatures between
4 °C and 40 °C.
Charge only using the charger provided with
the tool (see technical data).
When disposing of batteries, follow the
instructions given in the section “Protecting
the environment”.
Under extreme conditions, battery leakage
may occur. When you notice liquid on the
battery, proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
- In case of skin or eye contact, follow the
instructions below.
The battery fluid, a 25-30% solution of
potassium hydroxide, can be harmful.
In case of skin contact, immediately rinse
with water. Neutralise with a mild acid such
as lemon juice or vinegar. In case of eye
contact, rinse abundantly with clean water
for at least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the
contacts of a detached battery.
Do not incinerate the battery.
Chargers
Use your Black & Decker charger only to
charge the battery in the tool with which it was
supplied. Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-rechargeable
batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use
only.
ELECTRICAL SAFETY
Your charger has been designed for a specific
mains voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Your charger is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
Never attempt to replace the charger unit
with a regular mains plug.
PACKAGE CONTENTS
The pack contains:
1 Cordless screwdriver
1 Double-ended screwdriver bit
1 Charger
1 Instruction manual
Carefully unpack all parts.
Please note that additional items may be found
in the carton, depending on the letter suffix
following the catalogue number of your tool.
OVERVIEW (fig. A)
1. On/off switch with forward/reverse function
2. Bit holder
3. Charger connector
4. Charger
5. Battery
ASSEMBLY
Fitting and removing a screwdriver bit (fig. B)
To fit a screwdriver bit (6), push it into the bit
holder (2) until it locates.
To remove a screwdriver bit, pull it straight
from the bit holder.
USE
Let the tool work at its own pace.
Do not overload.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker KC9024 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker KC9024 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Spanish, Norwegian as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info