583266
6
Zoom out
Zoom in
Previous page
1/10
Next page
7
ENGLISH
Lift the spool (17) approximately 6mm (1/4")
from the spool housing (12), while pulling the
cutting line (5). This will allow you to lengthen
the line while clearing any line jammed inside
the spool. Ensure there is a minimum of 9cm
(3.5") protruding from the spool housing.
To replace the spool, rotate as necessary
and replace the cover by aligning both tabs
on the cover with the slots in the spool
housing and push into place. Ensure that
both tabs are securely located.
Line still jammed on spool
Disconnect the power supply and remove
the cover, as previously described.
Lift out the spool (17) completely, holding the
coiled cutting line in place to prevent it
unravelling from the spool (Fig. 7).
Carefully unwind the cutting line (5) from the
spool until any crossed or trapped loops are
cleared. Rewind the cutting line evenly, in the
direction of the arrows (16) on the spool.
Temporarily park the cutting line end in one
of the ‘L’ shaped slots to prevent the spool
unravelling. Ensure you leave a minimum of
9cm (3.5") protruding.
Turn the lever (14) backwards and forwards
to ensure it operates freely.
Remove any dirt or grass that may have
collected inside the spool housing and cover.
Feed the end of the line through the eyelet
and then push the spool into the centre drive
shaft while pulling the free end of the line to
release it from the ‘L’ shaped slot. To fully
seat the spool, rotate as necessary, taking
care not to trap the line underneath the
spool, and making sure that there is a
minimum of 9cm (3.5") of line protruding from
the spool housing.
Finally, replace the cover as previously
described.
Spool jammed
Remove the spool cover and the spool,
as previously described.
Remove any dirt or grass that may have
collected inside the cover and the
spool housing.
What to do if your trimmer
needs repair
Information on how and where to send your trimmer
for repair or service is given on the reverse of the
parts diagram. We recommend you keep this in
a safe place.
Australia/New Zealand: See Black & Decker under
‘Tools electric’ in your yellow pages.
Unwanted products and the
environment
Should you find one day that your product
needs replacement, or is of no further use to
you, think of the protection of the environment.
Black & Decker service centres will accept
your old products and will dispose of them in
an environmentally safe way.
Black & Decker Lawn and garden
guarantee
This guarantee provides: 36 months parts cover
and 12 months labour (UK), 24 months parts
cover and labour (Australia) and 12 months
replacement product cover (New Zealand).
In all cases proof of purchase will be required.
If your Black & Decker product becomes defective ,
within the guarantee period, due to faulty materials
and workmanship, we guarantee to either replace all
defective parts, or at our discretion, replace the unit
free of charge, provided that:-
The product is returned to us or our authorised
repairers with evidence of purchase.
The product has been used within the
parameters of its consumer classification.
The product has not been used for hire purposes.
Repairs have not been attempted by anyone other
than our own service staff or authorised repairers.
The failure represents normal wear and tear.
This guarantee is offered as an extra benefit and is
additional to your statutory rights.
The guarantee policy
Failures due to the following are not covered:-
Replacing worn or damaged blades, nylon line
and chains, or cables damaged during storage
or use. These are regarded as replacement items
which wear during normal usage.
Failures as a result of sudden impact or
obvious abuse.
Failures due to usage not in accordance with
instructions and recommendations contained in
the instruction manual.
The use of other than genuine Black & Decker
accessories and parts may damage or reduce the
performance of you Black & Decker product and
may render the guarantee void.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker GL570C T1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GL570C T1 in the language / languages: English as an attachment in your email.

The manual is 0,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker GL570C T1

Black Decker GL570C T1 User Manual - English, German, Dutch - 50 pages

Black Decker GL570C T1 User Manual - Danish - 20 pages

Black Decker GL570C T1 User Manual - French, Italian, Portuguese - 50 pages

Black Decker GL570C T1 User Manual - Swedish - 20 pages

Black Decker GL570C T1 User Manual - Spanish - 50 pages

Black Decker GL570C T1 User Manual - Norwegian, Finnish - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info