583266

Black Decker GL570C T1 Manual

4
Zoom out
Zoom in
Previous page
1/10
Next page
5
Edging
IBest results are achieved on edges greater
than 50mm deep.
Note: Your trimmer is a maintenance tool for
trimming overhanging grass and should not
be used to create edges. Edges can be
created using an edging spade.
JWith the skid (25) on the grass edge and the
edge guide (9) hooked over the edge, pull
the unit along while keeping the edge guide
in contact with the lawn edge.
A closer cut can be achieved by angling
the trimmer.
KIf your trimmer is suitable for use with a
‘Detachable’ extension cord, loop a length of
cord through the cord restraint (3) to avoid
the plug and socket coming apart
accidentally if the cord is pulled.
How to convert between the
trimming and edging mode (Fig. 3)
In addition to conventional trimming
(Fig. D), your trimmer can be used to trim
overhanging grass along lawn edges and
flower beds (Fig. J).
3To convert your trimmer between the
trimming and edging mode:
Unlock
•With the trimmer switched off and the
edge guide (9) resting on the ground,
place one hand on the switch handle
(20). Using your other hand, turn the
locking ring (4) anti-clockwise, as far as
it will go (approximately quarter of a turn)
(Fig. 3.1).
Convert
•While keeping hold of the switch handle,
grasp the trimmer body (1) and rotate
half a turn in the direction of the arrow
(24), until the body ‘clicks’ into position
(Fig. 3.2).
Lock
•While still holding the switch handle,
tighten the locking ring clockwise, using
the other hand. Only light finger pressure
is required to secure it (Fig. 3.3).
How to adjust the height of your
trimmer (Fig. 3)
Your trimmer has a telescopic body, thus
allowing you to alter its height to give you the
most comfortable operating position.
3To adjust the height of your trimmer:
Unlock
•With the trimmer switched off and the
edge guide (9) resting on the ground,
place one hand on the switch handle
(20). Using your other hand, turn the
locking ring (4) anti-clockwise,
approximately quarter of a turn (Fig. 3.1).
Adjust
•While keeping hold of the switch handle,
grasp the trimmer body (1) with your other
hand and raise/lower the switch handle
to your desired operating position (Fig. 3.4).
Lock
•While still holding the switch handle,
tighten the locking ring clockwise, using
the other hand. Only light finger pressure
is required to secure it (Fig. 3.3).
How to alter the position of the
secondary handle (Fig. L)
Your trimmer has an adjustable secondary
handle to allow you to position it for maximum
comfort and balance. It can be folded flat for
compact storage.
LTo adjust the handle:
•With the trimmer guard resting on the
ground, depress the button (27) with
your hand.
•While keeping the button depressed,
lift/lower the secondary handle to the
desired position with your other hand.
•Releasing the button will automatically
lock the handle in one of the preset
positions.
How to alter the cutting head angle
of your trimmer (Fig. M & N)
Your trimmer has a variable cutting head angle.
•To give you the optimum trimming angle
independent of your personal height
(Fig. C).
M•To raise the handle to a more comfortable
height when in the edging mode. Tip:
Alter the cutting head angle by lowering
the handle one or two knotches, while in
the trimming mode, prior to converting to
the edging mode (Fig. M).
ENGLISH
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker GL570C T1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GL570C T1 in the language / languages: English as an attachment in your email.

The manual is 0,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker GL570C T1

Black Decker GL570C T1 User Manual - English, German, Dutch - 50 pages

Black Decker GL570C T1 User Manual - Danish - 20 pages

Black Decker GL570C T1 User Manual - French, Italian, Portuguese - 50 pages

Black Decker GL570C T1 User Manual - Swedish - 20 pages

Black Decker GL570C T1 User Manual - Spanish - 50 pages

Black Decker GL570C T1 User Manual - Norwegian, Finnish - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info