Manual Black Decker CLM3820 T1 (page 12 of 164) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

586103

Zoom out

Zoom in

1/164

ENGLISH

(Original instructions)

Fitting the grass collection box (g. I & J)

u Lift the clear grass ap (12) and place the grass collection

box (9) over the lugs (20).

Wheel height adjustment (g. K & L)

Your mower features the Black & Decker Easy - height adjust-

ment system. This system will adjust all four wheels at the

same time.

The mower has six blade height adjustment positions (30 mm

to 80 mm). Refer to the scale on the side of the mower. The

pointer will indicate the height setting for cutting your lawn.

This setting can be a reference for the next time you want to

cut your lawn to the same height.

u Release the bail bar (2) to turn the lawnmower off, wait

until the blade stops and remove the safety key (1).

u To raise or lower the cutting height, place the palm of your

hand on the palm rest (21) and pull the height adjustment

lever (13) away from the mower body.

u Move the height adjust lever (13) into the required position

then push it back in towards the mower body.

Note: Make sure that the mower is securely locked in one of

the six positions.

Removing and tting the battery (g. O)

Before removing the battery:

u Place the mower on level ground.

u Release the bail bar (2) to turn the mower off, wait for the

blade to stop and remove the safety key (1).

To remove the battery:

u Pull the battery cover release (15) towards the front of the

mower body and lift the battery cover (14).

u Lift the battery (22) out of the mower.

To t the battery

u Pull the battery cover release (15) towards the front of the

mower body and lift the battery cover (14).

u Slide the battery (22) into the mower. (the battery will only

t one way.)

Use

Warning! Let the appliance work at its own pace. Do not

overload.

Charging the battery (g. M)

The battery needs to be charged before rst use and whenev-

er it fails to produce sufcient power on jobs that were easily

done before. The battery may become warm while charging;

this is normal and does not indicate a problem.

Warning! Do not charge the battery at ambient temperatures

below 10 °C or above 40 °C. Recommended charging tem-

perature: approx. 24 °C.

Note: The charger will not charge a battery if the cell

temperature is below approximately 0 °C or above 40 °C.

The battery should be left in the charger and the charger

will begin to charge automatically when the cell tempera-

ture warms up or cools down.

u To charge the battery (22), insert it into the charger (23).

The battery will only t into the charger in one way. Do

not force. Be sure that the battery is fully seated in the

charger.

u Plug in the charger and switch on at the mains.

The charging indicator (24) will ash green continuously

(slowly).

The charge is complete when the charging indicator (24)

lights green continuously. The charger and the battery can be

left connected indenitely with the LED illuminated. The LED

will change to ashing green (charging) state as the charger

occasionally tops off the battery charge. The charging indica-

tor (24) will be lit as long as the battery is connected to the

plugged-in charger.

u Charge discharged batteries within 1 week. Battery life will

be greatly diminished if stored in a discharged state.

Leaving the battery in the charger

The charger and battery pack can be left connected with the

LED glowing indenitely. The charger will keep the battery

pack fresh and fully charged.

Charger diagnostics

If the charger detects a weak or damaged battery, the charg-

ing indicator (24) will ash red at a fast rate. Proceed as

follows:

u Re-insert the battery (22).

u If the charging indicators continues ashing red at a fast

rate, use a different battery to determine if the charging

process works properly.

u If the replaced battery charges correctly, the original bat-

tery is defective and should be returned to a service centre

for recycling.

u If the new battery gives the same indication as the original

battery, take the charger to be tested at an authorised

services centre.

Note: It may take as long as 30 minutes to determine that

the battery is defective. If the battery is too hot or too

cold, the LED will alternately blink red, fast and slow, one

ash at each speed and repeat.

State of charge indicator (g. N)

The battery is tted with a state of charge indicator. This can

be used to display the current level of charge in the battery

during use and during charging.

u Press the state of charge indicator button (25).

Safety key (g. P)

Remove the safety key:

u Whenever leaving the appliance unattended.

u Before cleaning a blockage.

u Before checking, cleaning or working on the appliance.

u After striking a foreign object.

u Whenever the appliance starts vibrating abnormally.

Switching on and off (g. P & Q

Warning! Sharp moving blade. Never attempt to override the

operation of this switch and safety key system as a serious

injury could result.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker CLM3820 T1 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 8,68 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker CLM3820 T1

Black Decker CLM3820 T1 Quick start guide - English - 20 pages

Black Decker CLM3820 T1 User Manual - Polish - 24 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker CLM3820 T1 Manual

Product: