Manual Black Decker BHFEV36B2D (page 8 of 12) (English)

792731

Zoom out

Zoom in

1/12

ENGLISH (Original instructions)

To install battery pack (g. B)

uInsert battery (4) into tool until an audible click is heard as

shown in gure B.

uEnsure battery pack is fully seated and fully latched into

position.

To remove battery pack

uDepress the battery release button and pull battery pack

(4) out of the tool.

Assembly (Fig. C)

uAlign the top of the extension tube (9) with the vacuum

inlet (16) as shown in gure C.

uPush the extension tube (9) onto the vacuum inlet (16) so

it locks into position.

uAlign the bottom of the extension tube (9) with the oor

head (8) as shown in gure C.

uPush the bottom of the extension tube (9) onto the oor

head (8) so it locks into position.

uTo remove an accessory, press the accessory release

latch located on the accessory and pull it off.

USE

This vacuum cleaner can be used in one of four ways.

uWith the extension tube (9) and the oor brush (8) as

shown in gure C.

uWith the oor brush (8) and the vacuum inlet (16) as

shown in gure D.

uWith the extension tube (9) and an accesssory tool (10),

(11), (13) or (14) as shown in gure E.

uWith an accesssory tool (10), (11), (13) or (14) and the

vacuum inlet (16) as shown in gure E.

uAccessories not supplied with your unit can be ordered

through service department.

Switching ON and OFF (Fig. F)

uTo switch ON, press the On/Off button (1).

uFor increased power, slide the variable power switch (2)

forward.

Note: The oor brush (8) will power on when it is

attached to the vacuum or extension tube (it can be switched

off by pressing the button 2a on the display). The LED

worklights on the front of the oor head will illuminate

whenever the beater bar activation button (2a) is switched ON

(they can be switched off by pressing the button again).

Note: The state of charge indicator LEDs (3) will

illuminate while the vacuum is ON.

uTo switch OFF, press the On/Off button (1).

uReturn the battery to the charger immediately after use so

that it will be ready and fully charged for the next use.

Using an Accessory tool (Fig. G)

Your vacuum may come with some of the following tools.

u2 in 1 Accesssory tool (10)

uCrevice tool (11).

uPet hair tool (13).

uWide mouth dust brush (14).

uThe accessory tool (10), (11), (13) or (14) can be tted

either directly to the extension tube (6) or to the vacuum

inlet (5) as shown in Fig. G.

uAlign the top of the accessory tool (10), (11), (13) or (14)

with the vacuum inlet (16) or extension tube connection

(9a) and push into place so it locks into position as shown

in gure G.

Cleaning and emptying the vacuum

Filter agitator (Fig. H)

With the lift away dust canister (6) off the chassis (17) ,

rotate the lter agitator wheel 5 - 10 times to remove exces-

sive dust from the lter thus increasing its performance.

Note: It is recommended that you agitate when the unit is

emptied and the prelter removed.

Note: Maximum dust collection will only be obtained with

clean lters and an empty dust canister.

If dust begins to fall back out of the product after it is switched

off, this indicates that the dust canister is full and requires

emptying.

To empty the dust canister (Fig. I, J)

uLift and remove the lift away dust canister (6) from the

chassis (17) as shown in gure I.

uPlace the dust canister over a dust bin and press the

dust canister lid release button (6a) to empty the dust

canister as shown in gure J.

uClose the dust canister lid (7), until it “clicks” rmly

into position.

uInstall the lift away dust canister (6) back onto the

chassis (17).

Removing pre-lter (Fig. K)

uLift and remove the lift away dust canister (6) from the

chassis (17) as shown in gure I.

uPlace the dust canister over a trash bin and press the

dust canister lid release button (6a) to empty the dust

canister as shown in gure J.

uUse your index nger and thumb to pinch the pre-lter

(18), pull the pre-lter (18 ) from the dust canister (6) as

shown in gure K.

Note: The lter housing ts snuggly in the dust canister

and may be difcult to remove at rst.

uEmpty the dust canister.

uInstall the pre-lter (18) into the dust canister (6)

ensuring the dust canister tab (20) aligns with the prelter

slot (19) as shown in gure K.

uInstall the dust canister onto the vacuum, until it “clicks”

rmly into position.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker BHFEV36B2D in the language / languages: English as an attachment in your email.

The manual is 1.59 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker BHFEV36B2D Manual

Product: