53627

Black Decker BDV1084 Manual

7
Zoom out
Zoom in
Previous page
1/100
Next page
7
ENGLISH
X The digital display (2) shows FLO when topping off the
battery and returns to FUL when completed.
X To view the battery voltage, press the battery voltage
pushbutton (10).
Warning! If the battery size is not known, charge at the 2 A
rate. DO NOT overcharge batteries.
Alternator check (fig. A)
Warning! Check only 12 Vdc systems.
Part 1 (no load)
X Make sure that there is no load on the alternator by turning
off all the vehicle's accessories.
X The battery must be fully charged before testing the
alternator.
X Run the engine long enough to achieve normal idle speed
and verify that there is a no-load voltage.
X Press the alternator check pushbutton (9) to start the check.
X The alternator good LED (8) will light to indicate that the
alternator is good, or the fault LED (5) will display to
indicate that the alternator is out of typical voltage range.
X Press the alternator check pushbutton (9) again to stop the
test.
Part 2 (under load)
X Load the alternator by turning on as many accessories as
possible, except for air-conditioning and defrost.
X Press the alternator check pushbutton (9) to start the test.
X The alternator good LED (8) will light to indicate that the
alternator is good, or the fault LED (5) will light to indicate
that the alternator is out of typical voltage range.
X Press the alternator check pushbutton (9) again to stop the
test.
If the first alternator check indicates a good alternator and
the second indicates the alternator is not good, the problem
could be caused by any of the following:
X Loose fan belts.
X An intermittent diode failure.
X Bad connections between the battery and alternator and/or
ground.
Note: The battery voltage pushbutton (10) is disabled in the
alternator check mode.
Note: The fault LED (5) may display because a number of
extra accessory loads have been added to the charging
system, thereby increasing current demand from the
alternator. Make sure that the alternator is rated to support
the application.
Note: This check may not be accurate for every make,
manufacturer and model of vehicle.
Approximate charging times
The battery charger will automatically adjust the charge rate
as the battery becomes charged and stop charging when the
battery is fully charged. Deep cycle batteries may require
longer charging times.
For estimates of the time it takes to charge a battery, refer
to the following table:
*NR = Not recommended at 2 A - use a higher charge rate.
The times shown in the table above are approximate and
refer to a 50 Ah automotive battery.
Example
A 50 Ah, 12 Vdc battery is discharged (50%). To determine
the time it takes to charge at the 10 A rate, see the chart
above under "50%" and "at 10 A rate".
The battery charging times will vary depending on the size,
age and condition of the battery. Smaller batteries should be
charged at a lower rate (2 A) and an extra hour added to the
charge time.
Maintenance
Your Black & Decker tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
X From time to time wipe the appliance with a damp cloth. Do
not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water.
X After each use, clean the battery clamps (4) and be sure to
remove any battery fluid that will cause corrosion of the
clamps (4).
X Clean the outside case of the battery charger with a soft
cloth and, if necessary, mild soap solution.
X Do not allow liquid to enter the battery charger. Do not
operate when the battery charger is wet.
X Keep the battery charger cords loosely coiled during
storage to prevent damage to the cords.
% of charge in the battery
Rate 75% 50% 25% 0%
2A 7 hrs 14 hrs NR* NR*
6A 2.5 hrs 4.7 hrs 7 hrs 9.2 hrs
10A 1.4 hrs 2.8 hrs 4.2 hrs 5.5 hrs
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker BDV1084 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker BDV1084 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker BDV1084

Black Decker BDV1084 User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info