9
Weight: 44 kg
Guaranteed sound power level L
WA
: 95 dB(A)
Max. Temperature: 40 °C
Max. Altitude (above mean sea level): 1000 m
5. Parts Layout
1. Fuel gauge
2. Fuel cap
3. 230 V~ socket out lets.
4. 12Vd.c. connector out lets
5. Earth connection
6. Circuit breaker
7. Voltmeter
8. Oil ller plug
9. Oil drain nut
10. Engine switch
11. Choke lever
12. Pull cord
13. Petrol cock
14. Carry handle
15. Spanner
16. DC connecting cord
17. Air lter set
18. Spark plug
19. Spark plug wrench set
6. Before Use.
6.1 Important: Electrical safety
- Electric supply cables and connected
equipment must be in perfect condition.
- The generator is to be operated only with
equipment whose voltage specications
conform to the generator's output voltage.
- Never connect the generator to any other
power supply.
- Keep the cable length to the consumer as
short as possible.
6.2 Environmental protection
- Dispose of soiled maintenance material
and operating materials at the appropriate
collection point.
- Recycle packaging material, metal and
plastics.
6.3 Connecting to earth
-The housing is allowed to be connected to
earth in order to discharge static electricity.
To do this, connect one end of a cable to the
earth connection (5) on the generator and the
other end to an external earth (for example
an earth rod).
7. Operation.
7.1 Before starting the generator.
- You must ll up with engine oil (B12) and
fuel before you can start the engine.
- Check the fuel level and top it up if
necessary.
- Make sure that the generator has sufcient
ventilation.
- Make sure that the ignition cable is secured
to the spark plug.
- Inspect the immediate vicinity of the
generator.
- Disconnect any electrical equipment which
may already been connected to the generator.
- Permissible ambient temperature – 10 to +
40°C, max. altitude above sea level 1000 m,
relative humidity:90 %(noncondensing)
- Never use the generator in dusty area.
7.2 Starting the engine (reversing starter)
- Open the petrol cock (13) by turning it up.
- Move the engine switch (10) to position "I”.
- Move the choke lever (11) to position IØI.
- Start the engine with the pull cord (12) by
pulling the handle forcefully. If the engine
does not start, pull the handle again.
- Push the choke lever (11) back again after
the engine has started.
Important!
When starting with the pull cord, the motor