EN
5
On-site requirements
Electricity connection
For safe and trouble-free operation of your Rapido, please ensure the installation site meets the following requirements:
Make sure that the device will not fall over.
Do not place cloth under the unit.
Choose the installation location so that it is out of reach from children, including all electricity cables.
Only operate the device indoors.
For safe and trouble-free operation of the device, the following electricity connection instructions must be observed:
Before connecting the device, ensure that the voltage is 220-240 volts AC 50-60 Hz. This data must match to avoid damage
to the device. If in doubt ask your electrician.
Connect your steamer to an electrical outlet with the appropriate electricity values. These can be found on the rating plate
located on the down side and in the “Technical data” on page 22. Make sure that the power cord is plugged into the wall
outlet.
If the power cord is damaged, it must be replaced by the manufacturer or its service agent in order to avoid a hazard for the
user and third parties.
Electricity safety is only guaranteed when the device is connected to a protective conductor system and is properly installed.
The manufacturer assumes no responsibility for damages caused by an inadequate protective conductor.
Make sure that the power cord is undamaged and is not laid on hot surfaces or sharp edges.
The power cable must not be pulled too tightly.
Make sure that the plug is properly inserted in the socket. A loose plug can lead to overheating of the device or an electric
shock.
