715723
20
Zoom out
Zoom in
Previous page
1/96
Next page
20
2. Re-insert the filter cap [4] with a new filter.
3. Ensure that it is securely in place.
8. Cleaning and disinfection
Atomiser and accessories
Warning
Adhere to the following hygiene instructions to avoid
health risks.
The atomiser [7] and accessories are designed for mul-
tiple use. Please note that different areas of application
involve different requirements in terms of cleaning and
hygienic preparation.
Notes:
Do not clean the atomiser or the accessories mechan-
ically using a brush or similar device, as this could
cause irreparable damage and it will mean that the
best treatment results can no longer be guaranteed.
Please consult your doctor about the additional require-
ments in terms of the hygienic preparation required
(hand care, handling of medication/inhalation solutions)
for high-risk groups (e.g. patients with cystic fibrosis).
Ensure thorough drying after each cleaning or disin-
fection process. Residual moisture or wetness can
represent an increased risk of bacterial growth.
Preparation
Immediately after each treatment, all
parts of the atomiser [7] and the ac-
cessories used must be cleaned of re-
sidual medication and contamination.
Disassemble the nosepiece if you have
used it with the comfort attachment.
To do this, dismantle the atomiser [7]
into its individual parts.
Remove the mouth piece [10], the
mask [11, 12] or the nosepiece [13] from the atomiser.
Dismantle the atomiser [7] by twisting the top anti-
clockwise against the medication container [8].
Remove the atomiser insert [9] from the medication
container [8].
Reassembly is carried out in reverse order.
Cleaning
Important
The device must be switched off, disconnected from
the mains and allowed to cool down each time before
cleaning.
The atomiser and the accessories used such as the
mouthpiece, mask, etc. must be washed with hot but
not boiling water after each use. Dry the parts carefully
using a soft cloth. Put the parts together again when
they are completely dry and place them in a dry, sealed
container or disinfect them.
When cleaning, ensure that any residue is removed. Nev-
er use any substances for cleaning that could potentially
be toxic if they came into contact with the skin or mu-
cous membranes, or if they were swallowed or inhaled.
Use a soft, dry cloth and non-abrasive cleaning products
to clean the device.
Do not use any abrasive cleaning products and never
submerge the device in water.
Important
Ensure that no water gets inside the device.
Do not clean the device or accessories in the dish-
washer.
Do not touch the device with wet hands when it is
plugged in and do not allow water to spray on the
device. Only operate the device if it is completely dry.
If liquid penetrates the device this could cause damage
to the electrics or other nebuliser parts and lead to a
malfunction.
Condensation, hose care
Condensation may form in the hose depending on the
ambient conditions. It is essential to remove the moisture
to prevent bacterial growth and ensure proper treatment.
To do so, proceed as follows:
Remove the compressed air hose [6] from the atomiser
[7].
The hose must remain connected to the nebuliser[5].
Operate the nebuliser until the moisture is removed
by the air passing through.
In the event of heavy contamination, replace the hose.
8
9
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beurer IH 58 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beurer IH 58 in the language / languages: English, German, French, Italian, Polish, Turkish, Spanish as an attachment in your email.

The manual is 8,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info