752356

Bestway 58259 Manual

7
Zoom out
Zoom in
Previous page
1/92
Next page
RESET BUTTON
IMPORTANT INSTRUCTION FOR USING
If the water temperature has not changed 4-5 hours after activation of the heating system, use a thin object to press
the RESET BUTTON, and restart the heating system.
IMPORTANT: The heating system will not operate if the outside temperature is above 40°C (104°F) or if the Pool
Heater is under direct sunlight. Under these conditions, please wait until a cooler time of day before pressing the
RESET BUTTON with a thin object and restart the heating system.
NOTE: To order spare parts for the Pool Heater, please provide us with part no. and part name.
Drawings for illustration purposes only. May not reflect actual product. Not to scale.
RESET
P6124
Hose
Clamp P6176
Hose
P6005 O-Ring
Filter Pump
Above Ground Pool
Water Level
Sand Filter
P6124
P6124
Heating Reset
1. Be sure to press the "Reset" button on the
pool heater using a small and thin object before
initial operation
2. If the pool heater is not heating properly, press the "Reset"
button on the pool heater.
B
A
7
Operation
NOTE: Check the pool for correct installation and make sure both the pool’s
Inlet and Outlet Valves are fully covered with water before operating the Filter
Pump or Sand Filter with the Pool Heater. Make sure that the Pool Heater and
Filter Pump or Sand Filter are correctly connected.
1. Start the Filter Pump or Sand Filter according to the owner’s manual.
2. With the pump operating, insert the plug of the Pool Heater into a socket,
after test PRCD . The LED will light up for 0.5 seconds with a “beep” sound,
and the LED displays .
3. Press the “POWER” button for 2 seconds, the LED turns on and the heater
starts to work, the LED display .
4. Press the “POWER” button for 2 seconds again, the Pool Heater will turn off.
NOTE: When the water temperature reaches the maximum temperature
40°C (104°F), the LED turns green.
NOTE: Never plug in the Pool Heater until the Filter Pump or Sand Filter has
been plugged in.
WARNING: To prevent the risk of electrical shock, ensure your hands are
completely dry when plugging-in the Filter Pump or Sand Filter and the Pool
Heater.
NOTE: To prevent the risk of electrical shock, never run the Filter Pump or
Sand Filter and the Pool Heater when people are in the pool.
NOTE: Do not dry run the Pool Heater. Damage caused by dry running the
Pool Heater is not covered by the manufacturer’s warranty.
5. Remember to disconnect the Pool Heater first. Never unplug the Filter Pump
or Sand Filter when the Pool Heater is running.
6. Unplug the Filter Pump or Sand Filter and enjoy warm pool water!
Maintenance
CAUTION: YOU MUST UNPLUG THE POOL HEATER FIRST, THEN
UNPLUG THE FILTER PUMP OR SAND FILTER BEFORE PREFORMING
MAINTENANCE OR SEVERE RISK OF INJURY OR DEATH EXISTS.
1. Stop Water Flowing to the Filter Pump or Sand Filter and the Pool Heater:
a) Disconnect the Pool Heater and THEN the Filter Pump or Sand Filter.
b) Loosen the Hose Clamps on the pool’s Inlet and Outlet Hoses.
c) Replace the Debris Screens with the Stopper Plugs in the pool’s Inlet and
Outlet Valves.
d) Refer to the Filter Pump or Sand Filter ’s Owner’s Manual for information
on Filter Pump or Sand Filter maintenance.
2. After Filter Pump or Sand Filter maintenance, replace the Stopper Plugs with
the Debris Screens in the pool’s Inlet and Outlet Valves. Water will now flow
to the Filter Pump or Sand Filter and the Pool Heater.
3. Operate as outlined in the Operation section of this manual.
Storage and Winterization
CAUTION: YOU MUST UNPLUG THE POOL HEATER AND THE FILTER
PUMP OR SAND FILTER BEFORE MAINTENANCE BEGINS OR SEVERE
RISK OF INJURY OR DEATH EXISTS.
To avoid damage, pool equipment must be winterized when temperatures are
lower than 4°C (40°F). Allowing water to freeze will damage the Pool Heater
and void the warranty.
NOTE: Do not leave the heater out in the open air for long periods of time.
When it is not in use, please clean and dry it and then store it in a cool, dry
place.
1. Follow the instructions previously outline to stop water flowing to the Filter
Pump or Sand Filter and the Pool Heater.
2. Detach all hoses.
3. Drain any water in the Pool Heater and clean all components thoroughly.
4. Put the Pool Heater in a cool, dry place, out of children’s reach.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bestway 58259 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bestway 58259 in the language / languages: All languages as an attachment in your email.

The manual is 19,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bestway 58259

Bestway 58259 User Manual - English - 6 pages

Bestway 58259 User Manual - Dutch, French - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info