When installing and using this electrical appliance, basic safety precautions
should always be followed, including the following:
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
WARNING:
• The Pool Heater must be tested before each use.
• The Pool Heater must be supplied through a residual current device (RCD)
having a rated residual operating current not exceeding 30mA.
• Parts containing live parts, except parts supplied with safety extra-low
voltage not exceeding 12V, must be inaccessible to a person in the pool;
Parts incorporating electrical components, except remote control devices,
must be located or fixed so that they cannot fall into the swimming pool.
• The plug of Pool Heater shall be more than 3.5m away from the swimming
pool.
• RISK OF ELECTRIC SHOCK - The Pool Heater can not be used while
people are inside the pool.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• To reduce the risk of electric shock, do not use extension cords to connect
the unit to electric supply; provide a properly located outlet.
• Do not bury cord. Locate cord to minimize abuse from lawn mowers, hedge
trimmers, and other equipment.
• Do not switch on if there is a possibility that the water in the Pool Heater is
frozen.
• It is necessary to have the plug accessible after installation of the pool.
• Before using the Pool Heater, make sure the pool has been filled with
water.
• Pool Heaters are designed for used with specific water volume; ensure
your Pool Heater matches your pool’s water volume along with your Filter
Pump or Sand Filter’s designated water flow rate.
• RISK OF ELECTRIC SHOCK - Install at least 2m from all metal
surfaces.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensor or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
• To reduce the risk of injury, do not permit children to use this product
unless they are closely supervised at all times.
CAUTION:
•Pool Heater is for use with storable pools only. Do not use with
permanently-installed pools. A storable pool is constructed so that it is
capable of being readily disassembled for storage and reassembled to its
original integrity. A permanently-installed pool is constructed in or on the
ground or in a building such that it cannot be readily disassembled for
storage.
•Never add water to chemicals. Always add chemicals to water to avoid
strong fumes or violent reactions that may result in hazardous chemical
spray.
•The Pool Heater should not be setup or left out in temperature lower than
4°C (40°F).
NOTE:
•Ensure the Pool Heater is at least 2 meters away from poolside. Keep
distance as far as possible.
•Handle the Pool Heater with care. Do not pull or carry the Pool Heater by
the power cord. Keep cords free from abrasions. Sharp objects, oil,
moving parts, and heat should never be exposed to the Pool Heater.
•Please examine all equipment before use. Notify Bestway through our
customer service address listed on this manual for any damaged or
missing parts at the time of purchase. Verify all components represent the
model that you purchased.
•This product is not intended for commercial use.
IMPORTANT: Using the Pool Heater with an unmatched electrical supply is
dangerous and will result in catastrophic failure of the Pool Heater.
SAVE THESE INSTRUCTIONS
Meaning of crossed –out wheeled dustbin: Do not dispose of electrical
appliances as unsorted municipal waste, use separate collection
facilities.Contact your local government for information regarding the
collection systems available. If electrical appliances are disposed of in
landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated
to take back your old appliance for disposals at least free of charge.
Disposal
Specifications
Voltage:
Power:
Frequency:
Max. Heat Capability:
Increased Heat Rate (*):
Suitable Pool Water Volume:
Filter Pump/Sand Filter
Compatibility:
Pool Compatibility:
220-240V
2,800W at 20°C
50Hz
40°C
Approximately 0.5°C/h-1.5°C/h
depending on total water volume
400-5,000gal (1,520-18,930 L)
3,785 L/h (1,000 gal/h) and below
3,785 L/h (1,000 gal/h)
15’ and smaller
WARNING: The pool heater must be located in zone 2 or outside all zones.
The pool heater can not be put into the pool.
Zone 2Zone 1
Zone 0
Zone 0
Zone 22.5m
2.5m
1.5m1.5m2m2m
h
h
NOTE: The Increased Heat Rate is just for reference. The actual heating time may vary according to the pool’s water volume, environmental temperatures,
desired temperatures and other conditions. Usually, if the pool has a large water volume or if environment temperatures are low and the desired temperature
is high, longer heating time is required. However, if the temperature increase is less than 0.2°C after one heating hour, the water temperature can be thought
to have reached the highest balance temperature.
Installation Directions
ProblemCause
Troubleshooting
Solution
A. Power failure.A. Check power source.
A. The Pool Heater is not working
.
B. Heating time is too long
.
C. Filter pump or Sand Filter does not match the Pool
Heater appropriately or Filter Pump or Sand Filter
failed, resulting in high or low water flow rates.
D. Pool Heater set-up failed
.
E. The thermal cut out cut off
.
F. Pool Heater failed
.
A. Check the LED light to see whether the heater is working
.
B. Highly recommend the use of a Bestway pool cover
.
C. Filter Pump or Sand Filter needs to be replaced or repaired.
D. Reset-up the Pool Heater according to the instructions.
E. Press the “Reset” button on the Pool Heater
.
F. Contact after-sales service
.
A. Hose Clamps are loose
.
B. Hose O-ring not in correct position
.
C. Hose Broken
.
A. Tighten the hose clamps
.
B. Check whether O-Ring are damaged.
C. Hose needs to be replaced
.
A. Filter Pump or Sand Filter does not work
.
B. Filter Pump or Sand Filter broken
.
A. Reset-up the Filter Pump or Sand Filter according to the
instructions.
B.
Check and repair the Filter Pump or Sand Filter according to
the relevant instructions in the Filter Pump or Sand Filter’s
owner’s manual.
A. The light is broken.
A. The heating light is wrong and the heater still works.
1. The heating light does not work.
3. Pool Heater not heating properly.
4. Inlet and Outlet Valves leak.
5. Water does not flow.
6.
The heating light turns off but the Pool
Heater heats.
2. The heating light flashing.
A. Filter Pump or Sand Filter does not work.A. Reset-up the Filter Pump or Sand Filter according to the
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Bestway 58259 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Bestway 58259 in the language / languages: English as an attachment in your email.
The manual is 4,64 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
