800735
45
Zoom out
Zoom in
Previous page
1/88
Next page
45
EN
Cooling
1. Press the “MODE” button (Figure 1-F) once or more times, until the indicator light “COOL” lights up. The
device will now function as an air cooler and will cool the air by means of a cooling element.
2. Use the “UP” (Figure 1-D) “DOWN” (Figure 1-E) buttons to set the cooling temperature between 16 °C
and 31 °C.
3. Press on the “FAN” (Figure 1-C) button to switch between low or high speed for discharged air.
ATTENTION:
When the internal water collector is full, the appliance stops operating and the indicator light on the
control panel lights up “FULL”. You must empty the water collector before you can use the appliance
again (see ‘CLEANING AND MAINTENANCE - Water drainage’).
If you frequently use the appliance to dehumidify or cool air, you can also use the continuous discharge
(see ‘CLEANING AND MAINTENANCE - Water drainage’).
USE - Sleep mode
The device is equipped with a sleep mode. Enabling this function will allow the appliance to operate at its
quietest and most energy efficient setting
ATTENTION:
The sleep mode only works in the “COOL” mode.
1. Press the buttons “FAN” and “UP” (Figure 1-C and D) to enable the sleep function. The device switches
to the lowest and most energy-efficient setting.
2. Press the “FAN” and “UP” buttons again to disable the sleep function.
ATTENTION:
After switching off the sleep function, the device will remain in “COOL” mode.
USE - Timer mode
The device is equipped with a timer that allows you to switch the device on or off automatically.
Automatic power-on
When the appliance is switched off:
1. Press the “TIMER” button (Figure 1-B). The display starts to flash.
2. Use the button UP/DOWN to set the switch-on time between 1 and 24 hours.
3. Wait for the display (figure 1-A) to stop flashing. The switch-on timer is set.
4. Press the button again “TIMER” to adjust the switch-on time if necessary.
5. When the displays flash, press the button “TIMER” to turn off the timer.
Automatic power-off
When the appliance is switched on:
1. Press the “TIMER” button (figure 1-B). The display starts to flash.
2. Use the UP/DOWN button to set the power-off time between 1 and 24 hours.
3. Wait for the display (figure 1-A) to stop flashing. The power-off timer is set.
4. Press the “TIMER” button again to adjust the power-off time if necessary.
5. When the displays flash, press the “TIMER” button to turn off the timer.
USE - Remote control
The device can also be operated using the remote control included. The remote control works on two AAA
batteries (not included). Open the battery compartment on the bottom, insert the batteries and close the lid.
The buttons on the remote control function the same as the buttons on the control panel.
For optimal use:
Make sure the distance between the device and the remote control does not exceed 6 metres.
Point the remote control at the device and ensure the direction angle is less than 30 degrees.
The remote control has an extra button “SWING” to engage swing mode and move the airflow from top
to bottom. In addition, the slats can be adjusted to a desired position.
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bestron AAC12000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bestron AAC12000 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 3.3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info