614729
41
Zoom out
Zoom in
Previous page
1/140
Next page
39
ES FR ITES
Atención:
· Antes de enhebrar o sacar el hilo de la
máquina, colocar el interruptor
principal a "O".
· Al enhebrar la máquina tiene que estar
la palanca tira-hilo en su posición más
alta.
· Un mal enhebrado puede dañar la
máquina.
Para abrir la tapa del canillero hay que
empujarlo hacia adelante.
· Colocar la canilla de manera que el hilo
se devane en el sentido contrario a las
agujas del reloj.
· Colocar el hilo, conforme las marcas
con flechas, en la ranura guía-hilo
debajo del dedo (A) hasta la desviación
(B)
· Para estar segura que el hilo entre bien
en el muelle de tensión, hay que
presionar ligeramente con el dedo
sobre la canilla durante la colocación
del hilo. Controlar de la manera
siguiente: al tirar del hilo se debe notar
una resistencia del hilo.
· Colocar el hilo de la marca con flecha
(B) hasta (C) en la guía de la placa-
aguja.
Para cortar el hilo que sobra, pasar el hilo
en el punto (C) sobre la cuchilla y hacia
atrás.
Cerrar la tapa del canillero empujándola
hacia atrás.
Attention:
· Régler toujours l'interrupteur principal
sur "O" avant d'effectuer un enfilage
ou tout autre travail avec les aiguilles.
· Relever complètement le levier de fil
avant l'enfilage de la machine.
· Une erreur d'enfilage peut
endommager la machine.
Ouvrir le couvercle du support de canette
en le faisant coulisser vers l'avant.
· Placer la canette dans le support, le fil
doit se dérouler dans le sens contraire
des aiguilles d'une montre.
· Guider le fil le long des repères en
direction de la fente du guide fil sous
la tige (A) jusqu'au coude (B).
· Vérifier le fil qui doit être passé dans le
ressort de tension du support de
canette. Pendant l'enfilage, exercer une
légère pression sur la canette. Vérifier
en tirant sur le fil qui doit offrir une
certaine résistance.
· Introduire le fil dans le guide fil de la
plaque à aiguille en suivant les repères
de (B) à (C).
Découper le fil qui dépasse et tirer le fil du
point (C) vers l'arrière par-dessus la lame de
coupe.
Fermer le support du couvercle de la
canette en le faisant coulisser vers l'arrière.
Attenzione:
· mettere l’interruttore principale su "O"
prima di sfilare/infilare la macchina
· prima dell’infilatura la leva tendifilo
deve trovarsi nella posizione più alta.
· Un errore d’infilatura può
danneggiare la macchina.
Spostare il coperchio del crochet in avanti
per aprirlo.
· Inserire la spolina nel porta-spolina in
modo che il filo giri in senso anti-
orario.
· Passare il filo sotto l’intaglio (A) nella
direzione della freccia fino a (B)
· Premere leggermente con il dito sulla
spolina per assicurarsi che il filo si trovi
nella molla della tensione. Tirando il
filo - si deve sentire una certa
resistenza.
· Inserire il filo seguendo le frecce nelle
guide (B) e (C) della placca ago.
Tagliare il filo, passandolo sulla lama (C).
Per chiudere il coperchio del crochet,
spingerlo indietro.
Enfilage du fil de canetteFR Infilare il filo inferioreITEnhebrar el hilo inferior
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bernina Bernette Rome 7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bernina Bernette Rome 7 in the language / languages: German, French, Italian, Spanish as an attachment in your email.

The manual is 9,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bernina Bernette Rome 7

Bernina Bernette Rome 7 User Manual - English, Dutch, French - 137 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info