474163

Berner GA401 Manual

46
Zoom out
Zoom in
Previous page
1/67
Next page
ENGLISH
6.5.3
Operator fails to work with externally connected
buttons:
Check buttons, leads and connecting terminals.
ATTENTION
External voltage
not permitted.
6.5.4 Door does not close or open fully:
Door mechanics are stuck.
An obstruction is blocking the travel route.
Correct the door action or remove the obstruction.
Repeat learning procedure! See point 3.3.2.
6.5.5 Operator responds but door fails to open:
Check door latches and if necessary remove.
Transport carriage has not engaged with door link.
Check the emergency release.
6.5.6 Closing door changes direction:
Door mechanics are stuck.
An obstruction is blocking the travel route.
Correct door action or remove obstruction.
Repeat learning procedure in accordance with
point 3.2.2.
6.5.7 Lighting is defective:
Unplug from mains.
Remove view panel.
Check whether the halogen lamp is securely plugged in.
Replace halogen lamp (G 4 / 10 W, clear).
6.5.8 Insufficient range of radio remote control:
Check hand transmitter battery.
Correct aerial routing.
7 Terms and Conditions of Warranty
Warranty period
Over and above the statutory guarantee provided by the
dealer's Contract of Purchase, we grant the following
warranty from the date of purchase:
a) 60 months for driving mechanics, motor and motor
control
b) 24 months for radio system, radio system accessories
and special accessories and devices
No warranty for use-up components (z.B.: batteries, light
bulbs etc.)
Claims made under the warranty do not extend the
warranty period. The warranty period for replacement parts
and repair work is six months, at least, however, the initial
warranty period.
Prerequisites
Warranty claims are only applicable in the country where
the product was purchased. The product must have
been purchased through our authorised distribution
channels. The warranty only covers damage to the contract
object itself. Reimbursement of expenses for dismantling
and installing, inspecting corresponding components as
well as claims for lost profits and damages are not covered
by the warranty. The receipt of purchase substantiates
your right to claim under the warranty.
Performance
During the warranty period we undertake to rectify any
and all faults on the product which can be proved to
be attributed to a material or manufacturing defect. We
pledge to provide free of charge and at our discretion,
parts and service labour to repair or replace any part
of the product that fails due to a manufacturing defect,
to exchange the defective merchandise for faultless
merchandise or to grant a price reduction.
The warranty does not cover damage caused as a
result of:
- improper installation and connection
- improper use, putting into service and operation
- external influences, such as fire, water, abnormal
environmental conditions
- mechanical damage as a result of an accident,
a fall or impact
- negligent or wanton destruction
- normal wear and tear
- repairs carried out by non-qualified persons
- using parts of another manufacturer
- removing the product number or making it
unidentifiable
Replaced parts become our property.
8 Technical Data
Power supply: 230/240 V, 50/60 Hz
Standby approx. 1 W
Protection category: For dry rooms only
Automatic cutout: Is automatically programmed
separately for both operational
directions.
End-of-travel Self-learning, non-wearing,
cutoff / Force limit: since no mechanical switches
are used, additionally integrated
excess travel stop of approx. 140
s. Automatic cutout readjusts
itself during each door cycle.
Push and pull force: see type plate
Motor: DC motor with Hall sensor
Transformer: with thermal overload protection
Connection: Connection technique without
screws for external equipment
with safe low voltage of 24 V DC,
e.g. internal and external buttons
for impulse control.
Special functions: - Operator lighting
- STOP/cutout switch can be
connected
- Photocell, lockable
- border protection 8,2kΩ can
be connected
- border protection (Fraba) can
be connected
- warning light 230 V AC can
be connected
- Options relay for connecting
an external light
46
… 46 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Berner GA401 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Berner GA401 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info