657620
35
Zoom out
Zoom in
Previous page
1/87
Next page
68 69
MTB-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2016
ORIGINAL OPERATING INSTRUCTIONS 2016 | MTB-PEDELEC
b ca e fd
ENGLISH
ENGLISH
To measure the travel you can use the rubber ring mainly located on the thinner,
plunging tube of the suspension fork. If there is no rubber ring, tie up a cable tie
around one of the stanchion tubes. Make sure it is not too tight, you should still
be able to move it, it should however not slip by itself.
Put on your usual riding clothing (including if necessary a packed rucksack),
sit on your bike and bring yourself into the usual riding position. Lean against a
fixed object (railings, wall etc.) and make sure you do not fall over. Ask a helper
to move the rubber ring or the cable tie downwards against the dust seal at the
lower leg.
Get off your BERGAMONT bike so that the fork does not compress any more.
The distance between the rubber ring/cable tie and the wiper is the negative
suspension travel, or sag (d). Compare it with the total suspension travel (as
specified by the manufacturer) to determine whether the suspension should be
set to be harder or softer.
With pneumatic suspension forks the spring rate is set by the air pressure in
the fork. The pressure must be set before the first ride by means of a special
high-pressure pump with pressure gauge (e) and modified later as required due
to changes in the weight of the rider and/or load.
Note the appropriate setting values and check them subsequently at regular
intervals. Always follow the recommendations of the manufacturer and never
exceed the maximum air pressure for the suspension fork. Always make a test
ride after each change to the settings.
In the case of most suspension forks with coil springs a preload can be applied
to the springs within tight limits by turning a knob at the top of the fork crown
(f). If that is not possible and the desired negative suspension travel (“sag”)
cannot be set, the coil springs must be replaced by harder or softer models. The
replacement is a job for the BERGAMONT dealer.
When replacing any parts, be sure to only use parts that bear the appropriate
mark and, to be on the safe side, original spare parts. Your BERGAMONT dealer
will be pleased to help you.
FRONT SUSPENSION
Most of the BERGAMONT mountain bikes (a) and BERGAMONT pedelecs
(b) have suspension forks. This feature gives you better control of your
BERGAMONT bike when riding cross-country or on rough road surfaces and
ensures more ground contact for the tyre. It noticeably reduces the strain on
you and your bicycle caused by the mechanical shocks from the terrain.
Suspension forks differ in their types of spring elements and damping. Suspen-
sion forks normally work with air spring elements or less often with coil springs.
Damping is usually done by oil.
NOTE!
I
Suspension fork manufacturers normally include instructions with their
deliveries. Read them carefully before changing any settings or doing any
maintenance work on your suspension fork. You can find the instruction of the
suspension fork manufacturer on this BERGAMONT info CD.
NOTE!
I
For more information see the suspension glossary heading this chapter.
Adjusting the spring rate
To work perfectly, the suspension fork has to be adjusted to the weight of the
rider, the sitting posture and the intended use. Be sure to have this adjustment
carried out by your BERGAMONT dealer at the time of delivery.
Note in general that the suspension fork must give in a little even when you are
just sitting on the bike – this is the so-called negative suspension travel or sag
(c). When the front wheel passes through a depression in the ground, the spring
extends and the suspension fork will smooth out the uneven surface. If the air
pressure or the spring preload is too high, this effect is lost because the suspen-
sion fork is already fully extended. This means that an important comfort and
safety factor is lost if the tyre briefly loses contact with the ground.
In general, cross-country and marathon racers prefer a shorter negative sus-
pension travel (sag), whereas freeriders or downhillers riding often in rough
terrain prefer a longer one.. In the case of BERGAMONT cross-country and
BERGAMONT marathon bikes the suspension fork should yield by 15-25 % of
the maximum suspension travel, in the case of BERGAMONT all mountain,
BERGAMONT enduro and BERGAMONT freeride bikes by 25-35 %.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bergamont MTB - Pedelec at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bergamont MTB - Pedelec in the language / languages: English as an attachment in your email.

The manual is 21,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bergamont MTB - Pedelec

Bergamont MTB - Pedelec User Manual - German - 89 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info