657620
34
Zoom out
Zoom in
Previous page
1/87
Next page
66 67
MTB-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2016
ORIGINAL OPERATING INSTRUCTIONS 2016 | MTB-PEDELEC
b ca e fd
ENGLISH
ENGLISH
Travel adjust
In most case the suspension travel of the suspension fork is reduced by turning
a knob. There are some forks where the reduction is only realized after a deep
spring compression. In the case of full suspension rear frames this is typically
done by screwing off segments on which the rear shock is mounted or by loos-
ing or readjusting screws.
Compression damping (d)
In most cases a blue adjusting knob.
The damping which controls the rate at which the fork compresses. Prevents
the suspension fork from bottoming out when compensating very fast impacts.
Especially high-quality suspension elements distinguish between “high speed
(for hard impacts = rapid spring compression) and “low speed” (for slow com-
pression, e.g. bouncing when riding out of the saddle) compression damping.
Rebound damping (e)
In most cases a red adjusting knob.
The damping which controls the rate at which the forks extend after being com-
pressed. Prevents bike bobbing.
Lockout (f)
In most cases a lever on the suspension element or the handlebars.
A device to block the fork or the rear shock so that the suspension element
does not cause bob when riding on tarred roads or smooth surfaces. Not to be
used off road.
Platform damping
Increases the (low speed) compression damping rate and suppresses bobbing.
As opposed to the lockout function, the suspension is not blocked completely.
SUSPENSION ON BERGAMONT BIKES
GLOSSARY
Suspension fork
Bicycle fork (a) absorbing and damping shocks through moving components.
The most common among these forks are the telescopic suspension forks.
What is designated as stanchion tubes are the thinner tubes press fitted or
screwed to the fork crown of a telescopic fork. What is designated as lower leg
are the lower tubes in which the stanchion tubes slide in.
Rear shock
The rear shock (b) is the element which combines the spring as well as the
damping in the rear frame of a full-suspension bike. Often the rear shock is also
referred to as shock absorber.
Spring rate or hardness
The force that is required to compress the spring by a certain suspension travel
– measured in Newton per millimetre (N/mm) or pound per inch (lbs/in). A
higher spring rate requires more force for the travel. With air springs a higher
rate means a higher pressure.
Spring preload
In the case of the widespread air suspension systems, the air pressure in the fork
(c) is crucial for the spring rate and the spring preload. Observe your manufac-
turers recommendations.
Within a certain range a preload can be applied to the coil springs. Then the
suspension only reacts when a greater load is applied. The spring rate remains,
however, unaltered. Heavier riders cannot compensate a too soft spring rate
with a higher initial tension.
Negative suspension travel (“sag”)
The suspension travel that is taken up by the rear frame or the fork when the
rider takes up his or her usual riding position at a standstill. This is usually speci-
fied as a percentage of the overall suspension travel.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bergamont MTB - Pedelec at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bergamont MTB - Pedelec in the language / languages: English as an attachment in your email.

The manual is 21,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bergamont MTB - Pedelec

Bergamont MTB - Pedelec User Manual - German - 89 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info